Extreme Response Analysis Of An End-Anchored Floating Bridge

Zhengshun Cheng,Zhen Gao,Torgeir Moan
DOI: https://doi.org/10.1115/omae2019-96793
2019-01-01
Abstract:During the design of a floating bridge, extreme structural responses are required to be properly evaluated for ultimate limit state (ULS) design check. This study addresses the estimation of extreme structural responses for an end-anchored curved floating bridge. The floating bridge, about 4600 m, consists of a cable stayed high bridge part and a pontoon-supported low bridge part. The long-term extreme responses are approximated by using a engineering approach, i.e., the environmental contour method. The sea state with 100-year environmental conditions is considered, and a 90% fractile is used to calculate the short-term extreme responses by using the Gumbel method and the mean up-crossing rate (MUR) method based on 100 1-hour simulations with different seeds.The extreme responses are expressed as mu + kappa sigma , where mu and sigma are the ensemble mean and standard deviation, and kappa is a multiplying factor. Numerical results show that structural responses are close to Gaussian distributed. kappa of axial force and strong axis bending moment along the bridge girder estimated by both the Gumbel and MUR methods vary in the vicinity of 4. kappa estimated by the two method deviates, especially for axial force. Moreover, for both methods the estimated kappa deviates more significantly if fewer ensembles are used.
What problem does this paper attempt to address?