Analysis and Design Bjørnefjorden Floating Cable-Stayed Bridge subjected to Large Ship Collisions and Extreme Environmental Loads

Boyao Wang

Abstract:The highway E39 project is proposed by Norwegian Highway Authority (NPRA), it will connect Trondheim to Kristiansand with bridges building on the fjords. Due to the large span length and the depth of the water of the fjords, the floating bridge concept is proposed. The bridge will be supported by the pontoons floating on the water. In the navigation channel, there are two towers with the cables connecting the bridge girder. In reality, this bridge has a larger possibility of experiencing ship collisions. In this thesis, the local ship bow and pontoon is conducted to propose a safe pontoon design, then the global analysis of the bridge under ship collision has been done. A pontoon steel design that is highly resistant against ship collision is investigated. After obtaining the safe design of the pontoon, collision simulations are conducted between a container ship and the pontoon in order to obtain the force deformation curve for the ship. The force deformation curve is an essential input when doing the global analysis of the bridge since the contact force between the ship and pontoon is predicted based on the curve. The global response of the bridge that subjected to ship collision is analyzed in USFOS, where the finite element model of an entire bridge is built. The ship is modelled as mass spring system with given velocity. The original bridge model has been improved by adding the pre-tension in the cables and checking the balance of the bridge. Four different cases are investigated where the ship has different sailing direction and sailing speed. The difference in the first two cases is that they have different ship speed with collision energy 158.4MJ and 440MJ respectively. The third and forth cases have different collision angel relative to the pontoon, however they have the same collision energy 440MJ. The transverse displacement of the bridge ranges from 2.4m to 3.4m in the four cases. The results of the transverse displacement obtained in USFOS are quite close to the value from hand calculation of single degree of freedom. The collision force in the four cases is quite similar, the average value of the contact force is around 35MN. The absorbed energy by the ship ranges from 66% to 72%, the ship would drift away from the bridge. The largest spring permanent deformation is 9m, it happens in the forth case, where there is a small angel between the ship and pontoon. The response of the bridge deck that right upon the ship is investigated. It is found out the transverse bending moment is relatively large, because the ship-bridge collision happens at the middle point of the bridge, it is easy to trigger large transverse bending moment. The bridge design needs to be modelled with more details, some assumptions have been made, so the analysis of the bridge is conservative.

Engineering,Environmental Science