Abstract:Presented in this study is investigation of dynamic behavior of a helical gear reduction by experimental and numerical methods. A closed-loop test rig is designed to measure vibrations of the example system, and the basic principle as well as relevant signal processing method is introduced. A hybrid user-defined element model is established to predict relative vibration acceleration at the gear mesh in a direction normal to contact surfaces. The other two numerical models are also constructed by lumped mass method and contact FEM to compare with the previous model in terms of dynamic responses of the system. First, the experiment data demonstrate that the loaded transmission error calculated by LTCA method is generally acceptable and that the assumption ignoring the tooth backlash is valid under the conditions of large loads. Second, under the common operating conditions, the system vibrations obtained by the experimental and numerical methods primarily occur at the first fourth-order meshing frequencies and that the maximum vibration amplitude, for each method, appears on the fourth-order meshing frequency. Moreover, root-mean-square (RMS) value of the acceleration increases with the increasing loads. Finally, according to the comparison of the simulation results, the variation tendencies of the RMS value along with input rotational speed agree well and that the frequencies where the resonances occur keep coincident generally. With summaries of merit and demerit, application of each numerical method is suggested for dynamic analysis of cylindrical gear system, which aids designers for desirable dynamic behavior of the system and better solutions to engineering problems.

Tooth Dynamic Contact Simulation and Experimental Validation of Involute Spur Gear

Spur Gears Static and Dynamic Meshing Simulation and Tooth Stress Calculation

Tooth Contact Analysis of Involute Gear

Theoretical and Experimental Study on Contact Characteristics of Spiral Bevel Gears under Quasi-Static and Large Loading Conditions

On the extended tooth contact and nonlinear dynamics for spur gears—An analytical model

Angular velocity and contact force simulation of the spiral bevel gear meshing based on the hertz contact theory

Mathematic model and tooth contact analysis of a new spiral non-circular bevel gear

An improved dynamic model of spur gear transmission considering coupling effect between gear neighboring teeth

Static/dynamic Contact FEA and Experimental Study for Tooth Profile Modification of Helical Gears

Computerized Investigation of Real Tooth Contact Analysis of Face-milled Spiral Bevel Gears

Dynamic Modeling of Gear System Based on 3D Finite Element Model and Its Application in Spalling Fault Analysis

Dynamic analysis of gear pairs considering the actual contact state of truncated asperities on the 3D rough surfaces and force-dependent mesh stiffness

Mesh characteristic analysis and dynamic simulation of spur gear pair considering corner contact and tooth broken fault

Static/Dynamic Contact Finite Element Analysis for Tooth Profile Modification of Helical Gears

Contact Finite Element Method for Dynamic Meshing Characteristics Analysis of Continuous Engaged Gear Drives

Dynamic Modeling and Analysis of a Spur Planetary Gear Involving Tooth Wedging and Bearing Clearance Nonlinearity

Dynamic Meshing Contact Analysis for Plastic Gears Based on Finite Element Method

Hybrid Dynamic Modeling and Analysis of High-Speed Thin-Rimmed Gears

Dynamic analysis of a helical gear reduction by experimental and numerical methods

Analysis and Calculation of Gear Mesh Stiffness with Tooth Wear

Dynamic Modeling of Gear Tooth Pitting Propagation to Neighbouring and Mating Teeth