Abstract:Phase sensitive optical time domain reflectometry (Φ-OTDR) has been widely used in many applications for its distributed sensing ability on weak disturbance all along the sensing fiber. However, traditional Φ-OTDR cannot make quantitative measurement on the external disturbance due to the randomly distributed position and reflectivity of scatters within the optical fiber. Recently, some methods have been proposed to realize quantitative measurement of dynamic strain. In these literatures, the fiber with or without FBGs in practice was easily damaged and with difficulty of maintenance. PZT is employed to generate strain event in the fiber. There is a large gap compared with the real detecting environment, which will not reveal the full performance of the sensing system. In this paper, a distributed optical fiber sensing (DOFS) system for dynamic strain measurement based on artificial reflector is proposed and demonstrated experimentally. The fiber under test (FUT) is composed by four 20-meter long single mode optical fiber patch cords (OFPCs), which are cascaded with ferrule contactor/physical contact (FC/PC) connectors via fiber flanges. The fiber facet of FC/PC connector forms an artificial reflector. When the interval between the two reflectors is changed, the phase of the interference signal will also be changed. A symmetric 3×3 coupler with table-look-up scheme is introduced to discriminate the phase change through interference intensity. In our experiment, the center 10m section of the second OFPC is attached to the bottom of an aluminum alloy plate. An ordinary loudspeaker box was located on the top of the aluminum alloy plate. The dynamic strain generated by the loudspeaker box is transmitted from the aluminum alloy plate to the OFPC. Experimental results show that the proposed method has a good frequency response characteristic up to 3.2 kHz and a linear intensity response of R2=0.9986 while the optical probe pulse width and repetition rate were 100ns and 10 kHz respectively. Meanwhile, triangle and cosine amplitude-modulated (AM) dynamic strain applied on the fiber are successfully discriminated. The artificial reflectors based on FC/PCs were easily assembled and maintained, and the method of vibration transmission closely resembled the real circumstance than PZT. Therefore, these advantages will extend the potential of this Φ-OTDR technology in structure health monitoring.

Research on Dynamic Range Expansion Method of Fiber-Optic Distributed Acoustic Sensing

Coherent OTDR Based Ultra-High Sensitive Acoustic Sensor Assisted with Distributed Microstructured Optical Fiber(DMOF) and Hollow Cylinder Transducer

Coherent OTDR with large dynamic range based on double-sideband linear frequency modulation pulse

A Phase-Sensitive Optical Time Domain Reflectometry with Non-Uniform Frequency Multiplexed NLFM Pulse

Distributed optical fiber sensing based on the combination of Brillouin and Rayleigh scattering

A High Performance Distributed Optical Fiber Sensor Based on Φ-OTDR for Dynamic Strain Measurement

Large detection range and high strain sensitivity fiber SPR sensor based on wave structure

Dynamic strain sensing using Doppler-shift-immune phase-sensitive OFDR with ultra-weak reflection array and frequency-tracking

A Comprehensive Study of Optical Fiber Acoustic Sensing

A Distributed Optical Fiber Sensing System for Dynamic Strain Measurement Based on Artificial Reflector

Long-distance OFDR with High Spatial Resolution based on Time Division Multiplexing

Improvement of Dynamic Range in a Time Division Multiplexing Based Linear Sagnac Interferometric Sensor System

Fiber-optic distributed acoustic sensor based on a chirped pulse and a non-matched filter

Detection of Large Dynamic Range Acoustic Signal Using OPD-based Fiber-Optic Interferometric Demodulation with SNR Enhancement

Large-dynamic-range fiber loop ringdown strain sensor using Frequency-shifted Interferometry

Modulated Pulses Based High Spatial Resolution Distributed Fiber System for Multi-Parameter Sensing

Recent Progress in Distributed Fiber Optic Sensors

High-speed Quasi-Distributed Strain Sensing Based on Time Division Multiplexing of Fibre Bragg Gratings

Temperature Insensitive Distributed Wide-dynamic-range Strain Sensing based on Polarization-Maintaining Photonic Crystal Fiber

A High-Speed Demodulation Scheme for Phi-Otdr System Based on Dual-Sideband Modulation

Development of A Distributed Fiber Sensor for Simultaneous Strain and Vibration Measurement