Abstract:Quartz Crystal Microbalances (QCMs) are versatile sensors employed in various fields, from environmental monitoring to biomedical applications, owing mainly to their very high sensitivity. However, the assessment of their metrological performance, including the impact of conditioning circuits, digital processing algorithms, and working conditions, is a complex and novel area of study. The purpose of this work is to investigate and understand the measurement errors associated with different QCM measurement techniques, specifically focusing on the influence of conditioning electronic circuits. Through a tailored and novel experimental setup, two measurement architectures—a Quartz Crystal Microbalance with dissipation monitoring (QCM-D) system and an oscillator-based QCM-R system—were compared under the same mechanical load conditions. Through rigorous experimentation and signal processing techniques, the study elucidated the complexities of accurately assessing QCM parameters, especially in liquid environments and under large mechanical loads. The comparison between the two different techniques allows for highlighting the critical aspects of the measurement techniques. The experimental results were discussed and interpreted based on models allowing for a deep understanding of the measurement problems encountered with QCM-based measurement systems. The performance of the different techniques was derived, showing that while the QCM-D technique exhibited higher accuracy, the QCM-R technique offered greater precision with a simpler design. This research advances our understanding of QCM-based measurements, providing insights for designing robust measurement systems adaptable to diverse conditions, thus enhancing their effectiveness in various applications.

Uniformization of QCM’s Mass Sensitivity Distribution by Optimizing Its Metal Electrode Configurations

Investigation on Mass Sensitivity of N-M Type Electrode Quartz Crystal Microbalance

Design and Analysis of Quartz Crystal Microbalance with a New Ring-Shaped Interdigital Electrode

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Exploration of the Mass Sensitivity of Quartz Crystal Microbalanceunder Overtone Modes Using Electrodeposition Method

A Wireless Electrode-Free QCM-D in a Multi-Resonance Mode for Volatile Organic Compounds Discrimination

Overtone Mass Sensitivity of Quartz Crystal Microbalance Sensor with Asymmetric N-M Type Electrode Configuration.

Method for QCM Resonator Device Equivalent Circuit Parameter Extraction and Electrode Quality Assessment

Analysis and Amelioration about the Cross-Sensitivity of A High Resolution Moems Accelerometer Based on Diffraction Grating

High-sensitivity electrochemical dual-QCM for reliable three-electrode measurements

A wireless-electrodeless quartz crystal microbalance with dissipation DMMP sensor

Convergence of Dissipation and Impedance Analysis of Quartz Crystal Microbalance Studies

Online Ph Monitoring Based On A Wireless Electrodeless Quartz Crystal Microbalance With Dissipation

Development of a Flow Injection Based High Frequency Dual Channel Quartz Crystal Microbalance

Analysis of Quality Factor of the Quartz Crystal Resonator with N-M Asymmetric Electrodes

Quartz Crystal Microbalance Electronic Interfacing Systems: A Review

Quartz crystal microbalance based on torsional piezoelectric resonators.

Applications and Outlooks of Quartz Crystal Microbalance in Studies of Polymer Thin Films

Thickness shear mode quartz crystal resonators with optimized elliptical electrodes

Influence of Front-End Electronics on Metrological Performance of QCM Systems

An electrochemical quartz crystal microbalance (EQCM) based on microelectrode arrays allows to distinguish between adsorption and electrodeposition