Abstract:High performance thermal energy systems are crucial in fulfilling the growing demand of thermal energy. Consequently, numerous heat transfer enhancements have been proposed. Some of the promising methods are boiling flow heat transfer, helical coiled tube and metal foam insert. Although the performance of each strategy has been extensively studied, based on our literature review, the effectiveness of combining these strategies has not been investigated. This missing information may impede further development of efficient heat transfer systems. This study is therefore performed to investigate subcooled flow boiling heat transfer in helical tube with copper foam insert. A high-resolution three-dimensional pore scale model that considers the shape, porosity and pore density of the metal foam is developed and validated against the published experimental results. Using the model, the effect of inlet temperature, mass flux, wall heat flux, porosity, pore density and half-filled metal foam are studied. The results suggest that operating parameters have mild effects on the heat transfer performance. In contrast, porosity and pore density show significant influence in heat transfer coefficient and pressure drop. It has also been found that total heat transfer surface area and base area are better in characterizing heat transfer in pore-scale level than porosity and pore density at pore-scale level. Moreover, implementing metal foam at outer half of the tube is observed to offer slightly better heat transfer than implementing it at the inner side by around 4.8%. Overall, this study indicates that helical metal foam tubes offer the best performance at mass flux of 200 kg/m 2 ∙s with performance index of 0.72, while straight tubes with 0.90 porosity has the highest performance index of 0.66. Empirical correlations to relate dimensionless parameters to the Nusselt number and friction factor is generated. Finally, the model developed in this study can serve to provide guidelines for the upcoming studies in boiling in metal foam structure and assist in designing metal foam heat exchangers.

Experimental Study of Condensation Heat Transfer Characteristics on Metal Foam Wrapped Tubes under Sloshing Conditions

Experimental Study on Liquid Drainage Characteristics of Metal Foams under Sloshing Conditions

Experimental Investigation on the Heat Transfer Performance and Evaporation Temperature Fluctuation of a New-Type Metal Foam Multichannel Heat Pipe

An Experimental Study of Condensation Heat Transfer Characteristics Outside the Horizontal Metal Foam Tubes

Experimental Research on Flow Mode Transition of Falling Film Flow on Metal Foam Wrapped Tubes

Enhanced Convective Heat Transfer In High Porosity Metal Foams

Experimental Investigation on Pressure Drop and Heat Transfer in Metal Foam Filled Tubes under Convective Boundary Condition

Experimental Investigation on Heat Transfer Phenomenon in Metal Foam Filled Tubes

Flow Condensation in Tube Filled with Annular Metal Foam

Effects of Sloshing Motions on Condensation Heat Transfer Characteristics of Integral-Fin Tubes Under Sea Conditions

Experimental investigation on confined jet impingement boiling heat transfer characteristics on metal foam cover

Experimental Investigation on Enhanced Thermal Performance of Staggered Tube Bundles Wrapped with Metallic Foam

Influence of Pore Density on Heat Transfer and Pressure Drop Characteristics of Wet Air in Hydrophilic Metal Foams

Pore-scale Simulation of Forced Convection Heat Transfer under Turbulent Conditions in Open-Cell Metal Foam

Effect of Metal Foam on Heat Transfer Characteristics of Refrigerant/Oil Mixture Flow Boiling Inside Tubes

Experimental Investigation of Heat and Mass Transfer Characteristics of Moist Air in Metal Foam under Dehumidifying Conditions

Experimental investigation of permeability and Darcy-Forchheimer flow transition in metal foam with high pore density

Compression effect of metal foam on melting phase change in a shell-and-tube unit

Augmentation of pool boiling heat transfer on tube bundles using metal foam

Heat transfer analysis of subcooled flow boiling in copper foam helical coiled heat exchanger – A pore-scale numerical study

Optimizing thermal performance in tube-in-tube heat exchangers with metal foam inserts: experimental and RSM analysis