Abstract:Selective catalytic reduction (SCR) is a crucial technique for mitigating nitrogen oxides emission of internal combustion engines. Compared with vanadium-based catalysts, copper-based molecular sieve catalysts exhibit superior low-temperature catalytic performance and anti-aging properties. The catalytic characteristics of Cu-SSZ-13 catalyst in both fresh and aged states are investigated through experimental and numerical simulations. The catalytic performance of Cu-SSZ-13 catalyst with 200 g/L coating is investigated under wide inlet temperatures (180 °C–450 °C) and ANR (ammonia to nitrogen ratio) (1–1.4) conditions via an engine emission test device. Further, the apparatus is adopted to evaluate performance at various aging temperatures (600 °C, 700 °C, and 800 °C). The aging factor is introduced based on experimental results to establish and correct the kinetic model for SCR aging state. The results illuminate that the increase of ANR fails to compensate for decline of catalytic efficiency under low-temperature conditions (150 °C).The generated quantity of isocyanate acid through the side reaction of urea hydrolysis increases proportionally with ANR. And it increased supply only resulted in a marginal 1 %–3 % improvement of catalytic efficiency. As SV decreases from 60,000 h −1 to 35,000 h −1 , the catalyst efficiency increases from 22 % to 45 %, resulting in an elevation of reactant concentration and its gradient on the catalyst surface. This leads to accelerated reaction rates and enhanced diffusion effects. The catalytic efficiency can be significantly enhanced at low temperatures when NO 2 fraction in NOx falls within the range of 10 %–25 %. The sensitivity of SCR reactions to aging varies at low temperatures (<250 °C) due to the distinct reaction sites on catalyst for different types of SCR reactions. The NO 2 SCR reactions exhibit minimal susceptibility, while the rapid SCR reactions are significantly impeded. Moreover, it has been observed that the catalyst microstructure was completely deteriorated under hydrothermal aging test at 900 °C operating condition. In general, the low-temperature catalytic performance of Cu-SSZ-13 catalyst can be further optimized by pretreating inlet gas components and optimizing the catalyst structure.

Selective Catalytic Reduction Failure of Low NH3-NOx Ratio

Experimental study on selective catalytic reduction failure of low NH3-NOx ratio

Highly Efficient Fe-Cu/CL Catalysts Based on Low-Cost Clay Minerals for NH3-SCR of NOx at Low Temperature

Effects of Catalyst Physicochemical Properties on the Catalytic Activity of Cu Zeolite Selective Catalytic Reduction at Different Inlet Gas Conditions

Influence of Urea-SCR System Parameters on NOx Conversion Rate and Liquid Film

Experimental and numerical study of Cu-SSZ-13 SCR system for NOx reduction and hydrothermal aging under diesel exhaust conditions

Toward an Atomic-Level Understanding of the Catalytic Mechanism of Selective Catalytic Reduction of NOx with NH3

The Latest Research Progress of NH3-SCR in the SO2 Resistance of the Catalyst in Low Temperatures for Selective Catalytic Reduction of NOx

Recent Progress on Low-Temperature Selective Catalytic Reduction of NOx with Ammonia

Optimization Analysis of Various Parameters Based on Response Surface Methodology for Enhancing NOx Catalytic Reduction Performance of Urea Selective Catalytic Reduction on Cu-ZSM-13 Catalyst

Optimization of Isolated Copper Species on the NH3-SCR Performance over Cu/SSZ-39 Modified by Ammonia Water

Toward an Atomic-Level Understanding of the Catalytic Mechanism of Selective Catalytic Reduction of NO x with NH 3

Sulfur and Water Resistance of Carbon-Based Catalysts for Low-Temperature Selective Catalytic Reduction of NOx: A Review

Low-temperature selective catalytic reduction of NO<sub>x</sub> with NH<sub>3</sub> over zeolite catalysts: A review

Selective Catalytic Reduction of NO with NH3 over Sol-Gel-derived CuO-CeO2-MnOx/γ-Al2O3 Catalysts

Selective catalytic reduction of NO with NH 3 over sol-gel-derived CuO-CeO 2 -MnO x / γ -Al 2 O 3 catalysts

CFD-based investigation of NO x removal from industrial waste gas by selective catalytic reduction (SCR) and selective non-catalytic reduction (SNCR) process using NH 3

Experimental study on the performance and diagnosis of hydrothermally aged selective catalytic reduction over a copper-based catalyst

Molecular-Level Insight into Selective Catalytic Reduction of NOx with NH3 to N2 over a Highly Efficient Bifunctional Va-MnOx Catalyst at Low Temperature

Potential Risk of NH3 Slip Arisen from Catalytic Inactive Site in Selective Catalytic Reduction of NOx with Metal-Free Carbon Catalysts

Estimation of Ammonia Storage Nonuniformity for Urea-Based Selective Catalytic Reduction Systems