Abstract:The frequency response of phase-sensitive optical time-domain reflectometry ($\Phi $ -OTDR) is strictly limited by the repetition rate of the injected sampling pulses in conventional sensing scheme. To fully reconstruct an arbitrary vibration signal, the pulse repetition rate is required to be lower bounded by twice the maximum frequency of the vibration signal according to the Nyquist sampling theorem and at the same time upper bounded by the sensing fiber length to avoid generations of mixed Rayleigh backscattered signals from more than one optical pulse within the sensing fiber, making high-frequency vibration sensing over long distance impossible. In this work, we propose a novel method based on the serial multi-coset sampling (MCS) strategy which can recover sparse broadband vibration signals with sub-Nyquist sampling rates, which is thus able to break through the tradeoff between the measurable vibration frequency bandwidth and the sensing range. Pulses with non-uniform intervals are adopted to realize MCS for the Rayleigh backscattered lights along the entire sensing fiber rather than the traditional uniform pulse train. A continuous to finite (CTF) block is used to determine the active spectrum ranges of the sparse signal. By using a serial MCS sequence with an average sampling rate of 4.8 kHz, both a 4 kHz single-frequency sinusoidal signal and a 0.2 kHz bandwidth chirped signal with a center frequency of 4.6 kHz were sampled and recovered successfully in the simulation. In experiments, a single frequency vibration signal of 15 kHz and a chirped vibration signal with frequency ranging from 15 to 16 kHz were successfully identified and reconstructed over a sensing distance of 4 km using an average sampling rate of 21.6kHz, respectively, which however is not possible in conventional $\Phi $ -OTDR system. Furthermore, accurate identification of a broadband vibration signal with a maximum frequency of 6 kHz over a 10km-long sensing fiber shows that this method is also practically valid in long-distance sensing.

Simultaneous Temperature and Vibration Sensing Based on Hybrid BOTDR and Φ-OTDR

Pattern Recognition Based on Enhanced Multifeature Parameters for Vibration Events in Φ‐otdr Distributed Optical Fiber Sensing System

Hybrid B-OTDR/Φ-OTDR for Multi-Parameter Measurement from a Single End of Fiber

Ultra-Long-Distance Hybrid BOTDA/Ф-OTDR

A Hybrid Single-End-Access BOTDA and COTDR Sensing System Using Heterodyne Detection

A hybrid distributed optical fibre sensor for acoustic and temperature fields reconstruction

A New Designed FBG and Φ-OTDR Hybrid System for Vibration and Temperature Sensing

Non-Step-Scanning Rayleigh–Brillouin Distributed Fiber-Optic Sensing System Utilizing Double Sideband Modulation

A Hybrid Single-End-access MZI and Φ-OTDR Vibration Sensing System with High Frequency Response

Broadband Vibration Signal Measurement Based on Multi-Coset Sampling in Phase-Sensitive OTDR System

High spatial-resolved φ-OTDR system based on differential pulse width sequence technique

Modulated Pulses Based High Spatial Resolution Distributed Fiber System for Multi-Parameter Sensing

Strain-induced Vibration and Temperature Sensing BOTDA System Combined Frequency Sweeping and Slope-Assisted Techniques

A real-time detection and self-control phase-sensitive OTDR distributed sensor system

Distributed Strain and Vibration Sensing System Based on Phase-Sensitive OTDR

A Broadband Distributed Vibration Sensing System Assisted by a Distributed Feedback Interferometer

Distributed Single Fiber Optic Vibration Sensing with High Frequency Response and Multi-Points Accurate Location

High-Frequency Vibration Detection of Phase-Sensitive Optical Time-Domain Reflectometer

Phase-sensitive Optical Time-Domain Reflectometry with Heterodyne Demodulation

Quantitative Demodulation of Distributed Low-Frequency Vibration Based on Phase-Shifted Dual-Pulse Phase-Sensitive OTDR with Direct Detection

Distributed optical-fiber sensor combining Brillouin optical time domain analyzer with Mach-Zehnder interferometer