Abstract:<p>The paper presents the numerical investigations for a light civil helicopter fuselage with the purpose of reducing the helicopter drag. Two numerical methods: Reynolds-Averaged Navier-Stokes (RANS) and a hybrid RANS-LES method: improved delayed detached-eddy simulation (IDDES) method are performed for the simulation of a prototype helicopter fuselage. The RANS method is validated by a modular helicopter fuselage with experimental data, while the IDDES method has already been used in other studies and good results have been achieved. The numerical results of the civil helicopter in terms of the aerodynamic coefficients obtained by the two methods are consistent with each other. Compared to the RANS method, the IDDES approach is capable of predicting the large separation flow of the fuselage/components and the small-scale vortices in the flow field. It is found that the hybrid method captures the periodically detached separating vortices behind the skid struts, while the flow at the same position simulated by the RANS method is still attached. Moreover, separating vortices, which develop diagonally upwards, are captured at fuselage/tail-boom junction by the hybrid method, whereas RANS simulation doesn't predict. Subsequently, the design of the helicopter drag reduction is carried out at <span class="math"><math>α=0</math></span> deg angle of attack and 0.2 Mach number through shape optimization based on the numerical simulations, and the numerical results are verified by the force tests. It shows that the optimization of the landing skids aims at reducing the strong Karman vortex shedding effect induced by the skids, which greatly decreases the total drag. Combined with the optimization of the fuselage/tail-boom transition, this approach suppresses the separation flow of the fuselage and reduces the pressure drag, and the adjustment of transition slope benefits of up to 1.18% drag reduction, while the extension of transition reduces the drag by 2.64%. The optimization of tail-boom layout demonstrates that lower tail-boom layout can contribute to a drag reduction by 4.37% (RANS) and 3.89% (test), respectively, when compared to the original tail-boom layout.</p>

On Aircraft Lift and Drag Reduction Using V Shaped Riblets

Numerical Analysis of Turbulence Characteristics in a Flat-Plate Flow with Riblets Control

Riblet Surface Drag Reduction on Subsonic Aircraft

Numerical Study of Effect of Sawtooth Riblets on Low-Reynolds-Number Airfoil Flow Characteristic and Aerodynamic Performance

The Characteristic and Mechanism of Three Different Shapes of Riblets on Drag Reduction

Drag reduction using riblets downstream of a high Reynolds number inclined forward step flow

Numerical and Experimental Research of Flow Control on an NACA 0012 Airfoil by Local Vibration

Evaluation of viscous drag reduction on micro-machined riblet surfaces

Effect of Different Flow Directions on Drag over Riblet

Study of Riblet Drag Reduction for an Infinite Span Wing with Different Sweep Angles

Numerical Investigation of V-shaped Riblets and an Improved Model of Riblet Effects

Study on Riblet Drag Reduction Considering the Effect of Sweep Angle

Effect of riblet geometry on drag reduction of bionic riblet film

On the Tip Sharpness of Riblets for Turbulent Drag Reduction

Drag reduction of the turbulent boundary layer over divergent sawtooth riblets surface with a superhydrophobic coat

Numerical investigations on drag reduction of a civil light helicopter fuselage

Marine drag reduction of shark skin inspired riblet surfaces

On the drag reduction of an inclined wing via microstructures with the immersed boundary-lattice Boltzmann flux solver

Drag reduction mechanism of feather-like riblet film

Drag reduction by riblets

Numerical study of an airfoil with riblets installed based on large eddy simulation