Abstract:We demonstrate a novel transmission color filter design that exploits both dielectric and plasmonic resonances to establish a highly color-selective device, reaching an experimental full-width at half-maximum (fwhm) that is only half that of previously demonstrated cost-effective color filter devices for the same peak transmission and better out-of-band rejection. The measured fwhm is only 25 nm, and the peak transmission reaches up to 53%. The filter uses the interference of Fabry-Pérot resonances and guided-mode resonances in two separated dielectric slabs to achieve this excellent fwhm while relying on propagating surface plasmon polaritons to achieve the excellent out-of-band rejection. A simulation study elucidates the nature of the optical modes in the device and their interference mechanisms and reveals the most important design considerations. Fabrication was done in a CMOS pilot line and is cost-effective, as it requires only two metal patterning steps. Fabrication imperfections are discussed, together with strategies to mitigate them. We show the correct mitigation of these imperfections leads to further performance gain, enabling a full-width at half-maximum down to 20 nm and a peak transmission beyond 60%. We believe this novel filter design is a powerful concept to improve the spectral resolution of color filters for cost-effective multispectral imaging. Beyond multispectral imaging, the design could be adapted for other applications that require on-chip spectral filtering in a thin form factor.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsphotonics.1c01983.Table with dimensions of optimized unit cell designs for different pitches; Transfer matrix method applied to separate SiN sections to isolate Fabry-Pérot resonances; Simulated and measured transmission spectra for the orthogonal polarization (electric field parallel with the grating lines); Simulated transmission spectra for nonzero angle of incidence; Refractive index and extinction coefficient extracted from ellipsometry measurement (PDF)This article has not yet been cited by other publications.

Lithography-Free Nanofilm Color Filters Composed of CMOS-Compatible Materials

Single-color Peripheral Photoinhibition Lithography of Nanophotonic Structures

Compact Multilayer Film Structure for Angle Insensitive Color Filtering

P‐121: Angular‐Insensitive Color Filters Based on Compact Multilayer Film for Reflective Displays and Decorations

Spectral-Filtering Compact Film Structure Featuring Ultralow Electrical Resistivity

Angle Insensitive Color Filters Using Compact Multilayer Film Structures

Decorative near-infrared transmission filters featuring high-efficiency and angular-insensitivity employing 1D photonic crystals

Nanostructured Metal-Insulator-metal Resonators for High-Resolution Color Filtering and Spectral Imaging

Monolithic chip-scale structural color filters fabricated with simple UV lithography.

Ultra-Thin Plasmonic Color Filters Incorporating Free-Standing Resonant Membrane Waveguides with High Transmission Efficiency

Ultrabroadband, High Color Purity Multispectral Color Filter Arrays

Plasmonic Nanoresonators for High-Resolution Colour Filtering and Spectral Imaging.

Highly Selective Color Filters Based on Hybrid Plasmonic–Dielectric Nanostructures

Large-area, Lithography-Free Super Absorbers and Color Filters at Visible Frequencies Using Ultrathin Metallic Films

Silicon Color Filters for Light-Recycling Displays

Single-Layer Bayer Metasurface via Inverse Design

Polarization Tunable Color Filters Based on All-Dielectric Metasurfaces on a Flexible Substrate.

High saturation structural color based on lithography-free planar thin film with doped indium-gallium-zinc-oxide semiconductor

Silicon Metasurface Embedded Fabry-Perot Cavity Enables High Quality Transmission Structural Color

All-Dielectric Silicon Nanoring Metasurface for Full-Color Printing