Abstract:The discovery of an ordered L1 2 precipitate (Co 3 (Al, W)) phase in the ternary Co‐Al‐W system in 2006 which is stable up to temperatures of 950 °C attracts significant research on microstructure design for a new class of load‐bearing Co‐base high‐temperature alloys. The low mismatch between the fcc γ‐Co solid‐solution phase and the L1 2 γ'‐Co 3 (Al, W) phase helps to establish a microstructure with coherent cuboidal γ' precipitates embedded in a continuous γ matrix, analogous to Ni‐base superalloys. These new Co‐base superalloys have the potential to exhibit excellent high‐temperature mechanical properties and are considered to be ideal turbine blade materials. In the ternary Co‐Al‐W system, it is reported that the L1 2 phase is in equilibrium with the B 2 ‐CoAl and D0 19 ‐Co 3 W phases and transforms into those after extended annealing [1] . In order to increase the temperature capability and stabilize the γ'‐L1 2 phase, additional alloying elements are added to the Co‐Al‐W system. With additions of Cr, Mo, Ni, Re, Ta and V, the solidus and liquidus temperatures of Co‐Al‐W alloys are 100‐150 °C higher than those of advanced Ni‐base single‐crystal alloys strengthened by the L1 2 phase [2] . It is speculated in literature that Mo, V, Nb, Ta and Ti increase the γ' solvus temperature of Co‐Al‐W superalloys because they occupy B‐sites in the A 3 B ordered γ' phase and thereby increase its volume fraction, while Fe, Mn and Cr tend to distribute to the γ phase and decrease the amount of γ' phase [3] . Because the distribution of additional elements will influence the morphology and amount of the γ' phase, it is important to investigate their partitioning behavior and atomic site occupation in the Co‐Al‐W system. Therefore the high‐temperature strength and thermal stability of Co‐base superalloys are optimized. In this study, alloy samples with nominal compositions Co‐9Al‐9W‐2X (X=Ti, Nb, V, Ta, Cr and Mo, at.%) were produced. The partitioning behavior of the alloying elements between γ and γ' phases were investigated by energy‐dispersive X‐ray spectroscopy (EDS) in the transmission electron microscope (TEM). In order to analyze the element occupation at atomic sites, atom location by channeling enhanced microanalysis (ALCHEMI) technique was applied. The details about the partitioning behavior and the atomic site occupation of alloying elements will be discussed in the presentation.

Accelerating the Discovery of Novel Γ/γ' Co-based Superalloys by Probing Temperature and Alloying Effects on the Γ' Precipitates

First Principles Study on Structural Stability,mechanical,and Thermodynamic Properties of Γ'-Co3(v,m)(m=ti,ta)phase

Accelerating Exploitation of Co-Al-based Superalloys from Theoretical Study

Microstructures and Mechanical Properties of a L12-structured Precipitation Strengthened Co-based Superalloy

Theoretical Exploration of Alloying Effects on Stabilities and Mechanical Properties of γʹ Phase in Novel Co–Al–Nb-Base Superalloys

Co-Alloying Effects On The Site Preference And The Elastic Properties Of Gamma '-Ni3al From First-Principles Calculations

First Principles Study on Structural Stability, Mechanical and Thermodynamic Properties of γ'-Co 3 (V, M) (M=Ti, Ta) Phase

High-throughput exploration of alloying effects on the microstructural stability and properties of multi-component CoNi-base superalloys

Co-alloying effects on the site preference and the elastic properties of γ′-Ni3Al from first-principles calculations

Effects of Alloying Additions on the Microstructure, Lattice Misfit, and Solvus Temperature of a Novel Co–Ni-based Superalloy

ALLOYING EFFECTS ON HEAT-TREATED MICROSTRUCTURE IN CO-AL-W-BASE SUPERALLOYS AT 1300 degrees C AND 900 degrees C

Facilitated the discovery of new γ/γ′ Co-based superalloys by combining first-principles and machine learning

Element Partitioning and Atom Location of Alloying Elements in Co ‐base Superalloys

First-Principles Investigation Of The Site Preference And Alloying Effect Of Mo, Ta And Platinum Group Metals In Gamma '-Co-3(Al, W)

First-principles investigation of the site preference and alloying effect of Mo, Ta and platinum group metals in γ′-Co3γ′-Co3(Al,W)

Unveiling the Co Effect on the Temporal Evolution Kinetics of Γ′ Phase in Ni–Al–Co Model Superalloys Via CALPHAD–informed Phase Field Simulations

Enhancing structural stability of γ′-Co 3 (Al, Nb) phases: The key role of anti-site defects

Temperature Dependence of Thermodynamic Stability and Mechanical Property of Alloying Co3Ta Compounds

The Temperature Dependence of High-Temperature Strength and Deformation Mechanism in a Single Crystal CoNi-base Superalloy

Accelerating design of novel Cobalt‐based superalloys based on first-principles calculations

Microstructure, Phase Stability and Element Partitioning of Γ-Γ′ Co-9Al-9W-2X Alloys in Different Annealing Conditions