Abstract:Boundary Singularity Method (BSM) was used to model Chemical Vapor Infiltration (CVI) in a fibrous preform. Straight, long fibers of varying cross-sectional geometry, representing fibers of a preform, were placed within a domain of a pre-determined size. The preparation of dense fiber-reinforced Silicon-Carbon (SiC) composites was considered as a representative of CVI methodology, where methyl-trichlorosilane (MTS) was used as both the silicon and carbon donor for the silicon carbide matrix. Concentrations of MTS were then set at the domain boundaries, and the domain was gradually infiltrated with MTS as time progressed. The concentration of MTS at the surface of the preform fibers was calculated using the adopted BSM. For quasi-equilibrium considered, the reaction rate at solid surface is equal to the diffusion rate towards the surface. The Robin or third type boundary condition, which is a linear combination of the values of a function and the values of its derivative on the boundary of the domain, are developed and implemented to BSM. From the fibers surface concentrations obtained by BSM, deposition rates were calculated, and the geometry was updated to reflect the fiber growth during the time step, therefore, the fiber size growth and pore filling was modeled over time. The BSM analysis was verified by comparisons to a known analytical solution of concentric cylinders with a concentration set at the outer cylinder and a reaction at the inner. BSM solutions were also compared to experimental data as well as computational results obtained by a Level-Set Method (LSM). Obtained dynamics of pore size and location will help to evaluate quality of material manufactured by CVI. Porosity transients were obtained to show the relation between initial and current porosities as time progresses.

Homogenization of a Discrete Network Model for Chemical Vapor Infiltration Process

Numerical Simulation of Hypersonic Reaction Flows with Nonlinear Coupled Constitutive Relations

Modeling The Effects Of Reactor Inlet Configuration On Isothermal Cvi Process Of C/Sic Composites

Thermally Induced Diffusion of Chemicals under Steady-State Heat Transfer in Saturated Porous Media

Combinatorial Model of Solute Transport in Porous Media.

Probabilistic physics-integrated neural differentiable modeling for isothermal chemical vapor infiltration process

Chemical homogenization for non-mixing reactive interfaces in porous media

Modeling of Forced Flow-thermal Gradient CVI: Effects of Control Parameters and Processing Schemes on a Densification

A Coupled Vaporization Model Based on Temperature/species Gradients for Detailed Numerical Simulations Using Conservative Level Set Method

Homogenization of discrete mesoscale model of concrete for coupled mass transport and mechanics by asymptotic expansion

High-order models for convection–diffusion-reaction transport in multiscale porous media

Modeling for the Fabrication Process of a φ1185 mm C/C Composite Thermal Insulation Tube in an Isothermal Chemical Vapor Infiltration Reactor

On a Navier-Stokes-Cahn-Hilliard System for Viscous Incompressible Two-phase Flows with Chemotaxis, Active Transport and Reaction

Modeling of isothermal CVI process of C/C composites by fuzzy neural network

Modeling of Chemical Vapor Infiltration Using Boundary Singularity Method

Homogenization results for a coupled system of reaction-diffusion equations

A Continuum Mixture Model for Transient Heat Conduction in Multi-Phase Composites

Cross-diffusion systems coupled via a moving interface

Trans-level multi-scale simulation of porous catalytic systems: Bridging reaction kinetics and reactor performance

Analytical Model for Volatile Organic Compound Transport in the Coupled Vadose Zone-Groundwater System

Multiscale Models of CVD Process: Review and Prospective