Abstract:The major barriers for applying carbon dioxide (CO2) capture technology to coal-fired power plants in China and worldwide are the consequent drop in power plant energy efficiency and significantly higher cost of electricity (COE). This paper proposes a new perspective for determining the most cost-efficient CO2 capture ratio using a modeling and simulation approach that balances the per unit parasitic energy consumption for absorbent regeneration with the per unit capital cost of the CO2 capture unit of a coal-fired power plant. Using a typical 550 MW supercritical pulverized coal-fired power plant in China as the reference plant, with monoethanolamine (MEA) absorption unit for CO2 capture, a process model of the power generation unit together with the MEA CO2 capture unit was developed and detailed process simulations were conducted with the model. Then, a sensitivity analysis was then conducted to study the impact on key plant behavior indicators, including per unit energy penalty for absorbent regeneration, net power output and power generation efficiency, total capital cost of the power plant together with the MEA CO2 absorption unit, per unit capital cost of the MEA unit, COE, as well as the per unit CO2 avoidance cost (indicated by cost per tonne (t) CO2 avoided), across a CO2 capture ratio range between 20% and 99%. The results show that when CO2 capture ratio is low, while the unit energy consumption for absorbent regeneration per tCO2 avoided increases steadily with the increase of CO2 capture ratio, the cost per tCO2 avoided decreases as the MEA absorption train is scaled up given the high capital cost of each MEA train. After CO2 capture ratio reaches certain level (60% for this plant), the cost per tCO2 avoided starts to increase with CO2 capture ratio, since the unit energy consum- - ption for absorbent regeneration per tCO2 avoided has increased to so high that it supplants the scaling effect of the MEA train and becomes the dominant factor that determines the increase or decrease trend of the cost per tCO2 avoided. Besides, due to the physical restraint on the upper bound of CO2 capture capability of one single MEA train by the diameter of the absorber, an additional MEA train is needed when the CO2 capture ratio increases to certain points (40% and 85% for this plant), resulting in jumps of several parameters including the total capital cost for the power plant and MEA CO2 capture unit, per unit capital cost for the MEA CO2 capture unit, and last the cost per tCO2 avoided. Based on all these result, finally a cost-optimal CO2 capture ratio of 40% (365 RMB/tCO2-_avoided) was obtained, which is easier for the power plant to bear while realizing a significant reduction in CO2 emission of this plant. Therefore, applying this approach for determining CO2 capture ratios could help minimize the barrier for the initiation of carbon dioxide capture and storage (CCS) in China's power industry. Besides, future replacement or improvement for the MEA CO2 capture technology has the potential to further reduce the cost per tCO2 avoided, which needs special attention.

Thermodynamic and economic analysis of a new 600 MWe coal-fired power plant integrated with CaO-based carbon capture system

Thermodynamic Analysis of Coal-Fired Thermal Power Units Coupled S-CO2 Energy Storage System

Study on the Economic Operation of a 1000 MWe Coal-Fired Power Plant with CO2 Capture

Energy and Economic Assessment of Oxy-Fuel Combustion CO2 Capture in Coal-Fired Power Plants

An integrated de-carbonization supercritical coal-fired power plant incorporating a supplementary steam turbine, process heat recovery and a modified boiler structure

Thermodynamic and Economic Analysis of Oxy-Fuel-Integrated Coal Partial Gasification Combined Cycle

Different Cases Study on the Heating Surface Layout of a New 600 MWe Coal-Fired Power Plant Coupled with CaO-based Carbon Capture System Based on Heat Exchanger Network

Techno-economic Study of Carbon Capture from Coal-fired Power Plant Using MEA Assisted by Solar Organic Rankine Cycle for Power Generation

Thermo-economic analysis of a waste-to-energy assisted carbon capture system for a coal-fired power plant

Thermodynamic investigation of an integrated near-zero CO2 emission power generation system with SOFC, MGT, SCO2BC, and CO2 capture

The experience in the research and design of a 2 million tons/year flue gas CO2 capture project for coal-fired power plants

Reducing initial barriers for CCS deployment on pulverized coal-fired power plants in China by optimizing the capture ratio of carbon dioxide

Study on heat integration of supercritical coal-fired power plant with post-combustion CO2 capture process through process simulation

Energy, exergy and economic(3E) analyses of a CO 2 near-zero-emission power generation system with integrated supercritical water gasification of coal and SOFC

Progress and Prospect of CCS in China: Using Learning Curve to Assess the Cost-Viability of a 2×600MW Retrofitted Oxyfuel Power Plant As a Case Study

Pinch combined with exergy analysis for heat exchange network and techno-economic evaluation of coal chemical looping combustion power plant with CO<sub>2</sub> capture

Economic Analysis on Separation of CO2 from Coal-Fired Power Plant

Thermal economy simulation study for a carbon capture power plant with combined heat and power based on absorption heat pump technology

Process and Integration Optimization of Post-Combustion CO2 Capture System in a Coal Power Plant

Thermodynamic Analysis of 350 MWe Coal Power Plant Based on Calcium Looping Gasification with Combined Cycle

Heat Pump Assisted Sorption Carbon Capture with Steam Condenser Heat Recovery in a Decarbonised Coal-Fired Power Plant