Abstract:The blast pressure acting on the borehole wall is the basis of the dynamic analysis of rock blasting. The history of blast-induced borehole wall pressure (BWP) is difficult to measure owing to the complex interaction between the blasting load and the borehole wall, and the limitations of the general test system. In this work, the complete history of BWP under air-deck charge was measured for the first time, and the stress-response process was analyzed. PVDF (polyvinylidene fluoride) gages and a charge mode for the test circuit were employed. To improve the testing accuracy, the matching relationships among the parallel capacitor, the equivalent capacitance of PVDF gages, and the parasitic capacitance of the coaxial cable were effectively addressed. The experimental data within the span of 0–0.65 m from the explosive cartridge center show that there are two obvious peaks in the complete history of BWP, the first is a μs-level air shockwave load, followed by a ms-level explosion gas load. The peak of BWP is dominated by the peak of explosion gas ( P g ) within the scope of about 0–0.35 m from the explosive cartridge center, while is mainly determined by the peak of air shockwave ( P s ) in a farther range. The specific impulse distribution suggests that the explosion energy is mainly consumed in the area within the range of about 0–0.25 m from the explosive cartridge center. The strain rate in the borehole wall induced by air shockwave demonstrates a dynamic response (range of 131.9 ~ 2922.6 s −1 ), while indicating a quasi-dynamic loading (range of 0.1 ~ 2.1 s −1 ) when induced by the explosion gas. The findings contribute to expanding the understanding of the stress characteristics of the air shock wave and explosion gas and provide accurate initial loads for numerical simulation related to rock blasting of non-fluid–solid coupling.

Smart Blast Wave Storage Device And Data Analysis

Analysis of Energy Distribution for Digital Electronic Detonator Blasting

Research of Loading Effects of Blast in Air

Numerical Simulation of Shock Wave Caused by Underwater Blasting

Experimental study on the use of the ARM Cortex M7 processor for measuring far-field blast waves

Research on Energetic Micro-Self-Destruction Devices with Fast Responses

Device for Underwater Laboratory Simulation of Unconfined Blast Waves

Distributed Wireless Measurement System for Transient Pressure with Data Extraction Technology

Analysis of Energy Distribution of Accurate Millisecond Blasting Vibration

Computer Simulation of Dynamic Brittle Damage Process in Arch Dam Due to Blast Load

Dynamic Response and Blast-Resistance Analysis of a Tunnel Subjected to Blast Loading

miniBLAST: a novel experimental setup for laboratory testing of structures under blast loads

Design and implement of smart impact recorder for transformers

A Wireless Transient Attenuated-Exponential Overpressure Beamforming With for Far-Field Blast Source Localization

Identifying Delay Time of Detonator for a Millisecond Blasting

Experimental and Theoretical Analysis for Isolation Performance of New Combined Isolation Devices under Blast Loading

A Table-top Blast Driven Shock Tube

Blast Wave Simulator for Laminated Glass Panels Experimental Evaluation

The Integrated Micro Self-Adaptive Sampling Acceleration Measurement System

Triple-layer Absorptive Structures for Shock Wave Blast Protection

Measurement and Stress Response Analysis of Complete History of Blast-Induced Wall Pressure for Boreholes: A Case with Air-Deck Charge