Abstract:Vortex pumps have good non-clogging performance and are widely used in the fluid transportation of food, sewage treatment, and mineral and coal slurry transportation. In order to design and manufacture a vortex pump with good performance and establish a method of optimum design, we must master the internal flow rules of the pump. Based on the self-design vortex pump (32WB8-12) experiment, the discharge-pump head (qv-H), discharge-pump shaft power (qv-P), discharge-pump efficiency (qv-η), and discharge-critical net positive suction head (qv-NPSHc) curves are obtained, and the qv-NPSHc curve shows an opposite tendency compared with the centrifugal pump. With the mathematical model selected with respect to the optimal condition, the three-dimensional internal flow within the vortex pump has been numerically simulated by a renormalization group k-ε (RNG k-ε) turbulence model. The static pressure (ps) and velocity distribution of the impeller and the middle section of the volute at 0°, 90°, 180°, and 270° are obtained, and the performance curves have been fitted using a CFX-calculated energy parameter. It was illustrated that the velocity field is relatively disordered and the flow in the impeller region is of a forced vortex character. The flow in the volute is similar to that of the combined vortex with backflow, which is a non-axisymmetric unsteady flow with quite high turbulence intensity. These factors are the main reasons for the relatively low efficiency of the vortex pump. The measurement of flow field in volute with a five-hole probe was conducted, and it is demonstrated that the numerical results are in good agreement with the flow field measurement data. An upward pressure gradient forms in the portal area of the impeller, and it is confirmed that the lowest pressure point is located in the upper position of the impeller hub. It is revealed that for the vortex pump to have advanced suction and anti-cavitation performance, the lowest pressure in the pump should be −4 × 104 Pa and it should be located at the center of the vortex chamber cavity.

Study on Hydrodynamic Characteristics and Backwashing Efficiency of Three Types Turbines of Axial Dynamic Backwashing Technology for Oilfield Wastewater Filter

Study on the Performance of a 300W Counter-Rotating Type Horizontal Axis Tidal Turbine

Theoretical model and numerical simulation of high-gravity backwashing process for deep bed filter in oilfield

Structural Parameter Optimization of Hydraulic Vertox Separator in Recirculating Biofloc Technology System Based on Computational Fluid Dynamics

Study on Backwash Methods and Initial Filtered Water Turbidity Control of GAC-sand Filters

BACKWASHING PARAMETERS DETERMINATION BY ORTHOGONAL TEST FOR AEROBIC FILTER WITH AIR SCOUR PLUS SUBFLUIDIZATION WATER FLOW

Design and Optimization of A Large Flow Rate Booster Pump in Swro Energy Recovery System

A Performance Test and Internal Flow Field Simulation of a Vortex Pump

Optimization Study on a Novel High-Speed Oil-Free Centrifugal Water Pump with Hydrodynamic Bearings

Performance Analysis of the Vortex Cuttings Cleaner: Turbine Hydraulic Drive and Cuttings Transport in Wellbore Annulus

Three-dimensional Numerical Analysis on a New Design of Hydraulic Structure for Water Treatment

RESEARCH ON HYDRAULIC SELF-CLEANING FIBER FILTRATION

Hydraulic Optimization of Two-Way Counter-rotating Axial Flow Pump Turbine

Pilot-scale Test on Treatment of Backwash Wastewater by Ultrafiltration

Washing performance of microbubbles on porous media

Hydraulic Optimization and Performance Analysis of High Rotating Speed Pump As Turbine

Study On Backwashing Of Two- Phase Biological Aerated Filter

Investigation into Influence of Wall Roughness on the Hydraulic Characteristics of an Axial Flow Pump as Turbine

Numerical analysis of the impact of helical-blade design on flow characteristics and energy utilization in vertical-axis water turbine

Study on method of backwash of enhancing biological activated carbon filter

Experimental and numerical investigation of vortex flows and pressure fluctuations in a high-head pump-turbine