Abstract:Crack growth analysis (CGA) was applied to estimate the cycle life of the high-pressure hydrogen equipment constructed by the practical materials of 4340 (two heats), 4137, 4130X, A286, type 316 (solution-annealed (SA) and cold-worked (CW)), and type 304 (SA and CW) in 45, 85 and 105 MPa hydrogen and air. The wall thickness was calculated following five regulations of the High Pressure Gas Safety Institute of Japan (KHK) designated equipment rule, KHKS 0220, TSG R0002, JB4732, and ASME Sec. VIII, Div. 3. We also applied CGA for four typical model materials to discuss the effect of ultimate tensile strength (UTS), pressure and hydrogen sensitivity on the cycle life of the high-pressure hydrogen equipment. Leak before burst (LBB) was confirmed in all practical materials in hydrogen and air. The minimum K-IC required for LBB of the model material with UTS of even 1500 MPa was 170 MPa . mu in 105 MPa. Cycle life qualified 10(3) cycles for all practical materials in air. In 105 MPa hydrogen, the cycle life by K-IH was much shorter than that in air for two heats of 4340 and 4137 sensitive to hydrogen gas embriftlement (HGE). The cycle life of type 304 (SA) sensitive to HGE was almost above 10(4) cycles in hydrogen, while the cycle life of type 316 (SA and CW) was not affected by hydrogen and that of A286 in hydrogen was near to that in air. It was discussed that the cycle life increased with decreasing pressure or UTS in hydrogen. This behavior was due to that K-IH increased or fatigue crack growth (FCG) decreased with decreasing pressure or UTS. The cycle life data of the model materials under the conditions of the pressure, UTS, K-IH, FCG and regulations in both hydrogen and air were proposed quantitatively for materials selection for high-pressure hydrogen storage.

AN INTRODUCTION TO CHINA NATIONAL STANDARD FOR ON-BOARD HIGH-PRESSURE HYDROGEN STORAGE CYLINDERS

DESIGN AND OPTIMIZATION OF HIGH-PRESSURE HYDROGEN CYLINDERS FOR INTERMODAL CONTAINER TRANSPORTATION

Fatigue Test of Carbon Epoxy Composite High Pressure Hydrogen Storage Vessel under Hydrogen Environment

DEVELOPMENT OF STRIP WINDING HIGH PRESSURE HYDROGEN STORAGE VESSEL WITH LOW STRESS INNER LINER

Temperature Effects of Composite High Pressure Hydrogen Storage Cylinders in the Rapid Hydrogen Charging and Discharging Process

Structure design of mobile carbon fibre composite material high pressure hydrogen storage vessel

Research on Hydrogen Environment Fatigue Test System and Correlative Fatigue Test of Hydrogen Storage Vessel

Damage Assessment of Liquid Nitrogen Filling on Type III Cylinder in Cryo-Compressed Hydrogen Storage Cylinder

Study on Burst Pressure of Type Ⅳ Hydrogen Storage Cylinder Based on Progressive Failure Analysis

Challenges in Developing Linerless Composite Gas Cylinder for On-Board Hydrogen Storage

Review of Standards for Liquid Hydrogen Storage Vessels

Development of Regulations, Codes and Standards on Composite Tanks for On-Board Gaseous Hydrogen Storage

Stationary Flat Steel Ribbon Wound Vessels for Storage of High Pressure Hydrogen

Instability Analysis and Development of High Pressure Hydrogen Storage Vessels

Design Fatigue Life Evaluation of High-Pressure Hydrogen Storage Vessels Based on Fracture Mechanics

Crack Growth Analysis Of High-Pressure Equipment For Hydrogen Storage

Development of High Pressure Gaseous Hydrogen Storage Technologies

Small-Scale High-Pressure Hydrogen Storage Vessels: A Review

BONFIRE TEST AND NUMERICAL SIMULATION OF HIGH-PRESSURE HYDROGEN STORAGE CYLINDERS FOR VEHICLE

High Pressure Steel Storage Vessels Used in Hydrogen Refueling Station

Bonfire Test and Different Filling Mediums' Numerical Comparison Research of High-Pressure Hydrogen Storage Cylinders for Vehicle