Abstract:Steel wire ropes, which are usually composed of a polymer core and enclosed by twisted wires, are used to hoist heavy loads. These loads are different structures that can be clamshells, draglines, elevators, etc. Since the loading of these structures is dynamic, the ropes are working under fluctuating forces in a corrosive environment. This consequently leads to progressive loss of the metallic cross-section due to abrasion and corrosion. These defects can be seen in the forms of roughened and pitted surface of the ropes, reduction in diameter, and broken wires. Therefore, their deterioration must be monitored so that any unexpected damage or corrosion can be detected before it causes fatal accident. This is of vital importance in the case of passenger transportation, particularly in elevators in which any failure may cause a catastrophic disaster. At present, the widely used methods for thorough inspection of wire ropes include visual inspection and magnetic flux leakage (MFL). Reliability of the first method is questionable since it only depends on the operators’ eyes that fails to determine the integrity of internal wires. The later method has the drawback of being a point by point and time-consuming inspection method. Ultrasonic guided wave (UGW) based inspection, which has proved its capability in inspecting plate like structures such as tubes and pipes, can monitor the cross-section of wire ropes in their entire length from a single point. However, UGW have drawn less attention for defect detection in wire ropes. This paper reports the condition monitoring of a steel wire rope from a hoisting elevator with broken wires as a result of corrosive environment and fatigue. Experiments were conducted to investigate the efficiency of using magnetostrictive based UGW for rope defect detection. The obtained signals were analyzed by two time-frequency representation (TFR) methods, namely the Short Time Fourier Transform (STFT) and the Wavelet analysis. The location of the defect and its severity were successfully identified and characterized.

The Effect of Variable Tensile Stress on the Mfl Signal Response of Defective Wire Ropes

Distinguish Abnormal Tensile and Torsional Stresses of Steel Wire Rope Using Magnetoelastic Effect.

Magnetic Flux Leakage Testing of Wire Rope Defects with Denoising

Detecting and Locating Local Flaws Based on Magnetic Flux Leakage Imaging for Wire Ropes

Simulation analysis and experimental investigation of wire rope leakage magnetic field detection

Research on the force-magnetic coupling of steel wire and defect evaluation based on self-magnetic flux leakage effect

Quantitative Detection of Local Flaw under the Lift-Off Effect for Steel Wire Ropes

Tension Monitoring and Defect Detection by Magnetostrictive Longitudinal Guided Wave for Fine Wire Rope.

A New Signal Processing Method for the Nondestructive Testing of a Steel Wire Rope Using a Small Device

Fatigue damage evaluation and verification of steel wire rope based on magnetic flux leakage

Advanced signal processing methods applied to guided waves for wire rope defect detection

Fault Diagnosis of Steel Wire Ropes Based on Magnetic Flux Leakage Imaging Under Strong Shaking and Strand Noises

Quantitative Method for Defect Surface Area of Wire Rope Based on Circumferential Magnetic Flux Leakage Image

Wire Rope Defects with the Micro-magnetic NDT Technology

Instantaneous Lift-off Distance Estimation in Magnetic Flux Leakage Testing of Steel Wire Ropes

Extraction of weak signal based on wire rope detection in timing belt of wind turbines

Evaluation of rope strand noise in wire ropes inspection using the magnetic flux leakage testing

Online Nondestructive Testing for Fine Steel Wire Rope in Electromagnetic Interference Environment

Magnetic Flux Leakage Sensing and Artificial Neural Network Pattern Recognition-Based Automated Damage Detection and Quantification for Wire Rope Non-Destructive Evaluation

Enhancing Wire-Rope Damage Signals Based on a Radial Magnetic Concentrator Bridge Circuit

Eliminating Shaking Noise for Defect Detection of Steel Wire Ropes Based on Magnetic Flux Leakage Signals