Combustion and Emissions of RP-3 Jet Fuel and Diesel Fuel in a Single-Cylinder Diesel Engine

Tongbin Zhao,Zhe Ren,Kai Yang,Tao Sun,Lei Shi,Zhen Huang,Dong Han
DOI: https://doi.org/10.1007/s11708-021-0787-3
2021-01-01
Frontiers in Energy
Abstract:The combustion characteristics and emission behaviors of RP-3 jet fuel were studied and compared to commercial diesel fuel in a single-cylinder compression ignition (CI) engine. Engine operational parameters, including engine load (0.6, 0.7, and 0.8 MPa indicating the mean effective pressure (IMEP)), the exhaust gas recirculation (EGR) rate (0%, 10%, 20%, and 30%), and the fuel injection timing ( - 20, - 15, - 10, and - 5° crank angle (CA) after top dead center (ATDC)) were adjusted to evaluate the engine performances of RP-3 jet fuel under changed operation conditions. In comparison to diesel fuel, RP-3 jet fuel shows a retarded heat release and lagged combustion phase, which is more obvious under heavy EGR rate conditions. In addition, the higher premixed combustion fraction of RP-3 jet fuel leads to a higher firststage heat release peak than diesel fuel under all testing conditions. As a result, RP-3 jet fuel features a longer ignition delay (ID) time, a shorter combustion duration (CD), and an earlier CA50 than diesel fuel. The experimental results manifest that RP-3 jet fuel has a slightly lower indicated thermal efficiency (ITE) compared to diesel fuel, but the ITE difference becomes less noticeable under large EGR rate conditions. Compared with diesel fuel, the nitrogen oxides (NO x ) emissions of RP-3 jet fuel are higher while its soot emissions are lower. The NO x emissions of RP-3 can be effectively reduced with the increased EGR rate and delayed injection timing.
What problem does this paper attempt to address?