Abstract:Internet-of-Things (IoT) refers to a high-density network of low-cost low-bitrate terminals and sensors where also low energy consumption is one central feature. As the power-budget of classical receiver chains is dominated by the high-resolution analog-to-digital converters (ADCs), there is a growing interest towards deploying receiver architectures with reduced-bit or even 1-bit ADCs. In this paper, we study waveform design, optimization and detection aspects of multi-user massive MIMO downlink where user terminals adopt very simple 1-bit ADCs with oversampling. In order to achieve spectral efficiency higher than 1 bit/s/Hz per real-dimension, we propose a two-stage precoding, namely a novel quantization precoder followed by maximum-ratio transmission (MRT) or zero-forcing (ZF) type spatial channel precoder which jointly form the multi-user-multiantenna transmit waveform. The quantization precoder outputs are optimized, under appropriate transmitter and receiver filter bandwidth constraints, to provide controlled inter-symbol-interference (ISI) enabling the input symbols to be uniquely detected from 1-bit quantized observations with a low-complexity symbol detector in the absence of noise. An additional optimization constraint is also imposed in the quantization precoder design to increase the robustness against noise and residual inter-user-interference (IUI). The purpose of the spatial channel precoder, in turn, is to suppress the IUI and provide high beamforming gains such that good symbol-error rates (SERs) can be achieved in the presence of noise and interference. Extensive numerical evaluations illustrate that the proposed spatio-temporal precoder based multiantenna waveform design can facilitate good multi-user link performance, despite the extremely simple 1-bit ADCs in the receivers, hence being one possible enabling technology for the future low-complexity IoT networks.

Introduction to the Issue on Hybrid Analog-Digital Signal Processing for Hardware-Efficient Large Scale Antenna Arrays (part II)

A Hybrid Beamforming Receiver with Two-Stage Analog Combining and Low-Resolution ADCs

Hybrid Architectures with Few-Bit ADC Receivers: Achievable Rates and Energy-Rate Tradeoffs

BER Performance of Uplink Massive MIMO With Low-Resolution ADCs

Doubly 1-Bit Quantized Massive MIMO

Hybrid Analog-Digital Precoding for Interference Exploitation

Hybrid Receiver Design for Massive MIMO-OFDM with Low-Resolution ADCs and Oversampling

Resolution-Adaptive Hybrid MIMO Architectures for Millimeter Wave Communications

One-bit Massive MIMO Precoding Via a Minimum Symbol-Error Probability Design

Digital and Hybrid Precoding Designs in Massive MIMO with Low-Resolution ADCs

Massive MIMO 1-Bit DAC Transmission: A Low-Complexity Symbol Scaling Approach

Hybrid Precoder and Combiner Design with Low Resolution Phase Shifters in mmWave MIMO Systems

Transmit Signal Design for Large-Scale MIMO System with 1-Bit DACs

Secure Hybrid Digital and Analog Precoder for mmWave Systems with low-resolution DACs and finite-quantized phase shifters

Receiver Design and SER Analysis of Massive MIMO Uplink with Mixed-Resolution ADCs

Limited Feedback Hybrid Precoding for Multi-User Millimeter Wave Systems

Spatio-Temporal Waveform Design for Multi-user Massive MIMO Downlink with 1-bit Receivers

Antenna Selection Strategies for Massive MIMO Systems with Limited-Resolution ADCs/DACs

Detection Schemes with Low-Resolution ADCs and Spatial Oversampling for Transmission with Higher-Order Constellations in the Terahertz Band

BER Performance Analysis of Coarse Quantized Uplink Massive MIMO

An Efficient Design of One-Bit DACs Precoding for Massive MU-MIMO Downlink