Abstract:The cutters on the cutterhead of a tunnel boring machine (TBM) are usually divided into center cutters, face cutters, and gage cutters, and have significantly different force characteristics. In this study, the authors conduct a series of full-scale cutter rotary cutting tests to compare the differences in the cutter force, the morphology of rock ships, and the efficiency of rock breaking. The results indicate that with increasing cutter spacing, the influence exerted by the cutters on one another in terms of their performance at breaking rocks decreases and their normal force gradually increases, while the rolling force of the cutters is less influenced by the spacing between them. The ratio of the normal force to the rolling force of the gage cutter is less than that of the face cutter, indicating a lower efficiency of breaking rock of the gage cutter. The ratio of rock chips with larger size (>50 mm) and smaller size (<10 mm) gradually decreases while that of rock chips with medium size (about 10–50 mm) gradually increases with increasing installation angle, such that the distribution of the particle size becomes more uniform. Excessive or insufficient penetration rate (PR) will increase the proportion of small rock chips, and a moderate PR will produce rock chips with a larger characteristic size and a more uniform size distribution. Then, a three-dimensional rock-breaking model by all cutters of actual TBM cutterhead is established based on the particle flow method. The results of the simulations indicate that the force on the inner ring of the center cutter is greater than that on the outer ring, and an increase in the installation radius weakens the load difference between the two rings. The normal and rolling forces of face cutters gradually increase, while their side force first increases and then decreases. The side force of the gage cutter significantly increases with the installation angle.

Mechanical Analysis Of Removable Blocks During Tbm Tunnelling In Blocky Rock Masses In View Of Tbm-Block Interaction

Study Of Surrounding Rock Damage Induced By Tunnel Boring Machine Driving Tunnel At West Route Of South To North Water Transfer Project

Performance Evaluation of TBM Using an Improved Load Prediction Model

Dynamic characteristic analysis of TBM tunnelling in mixed-face conditions

Do Small Block Treatments Matter in Block Identification for Rock Block System Mechanical Analysis?

Stability analysis of underground surrounding rock mass based on block theory

Study of the cutter-rock interaction mechanism during TBM tunnelling in mudstone: insight from DEM simulations of rotatory cutting tests

Analysis on the Rock–Cutter Interaction Mechanism During the TBM Tunneling Process

Mechanical Performance of TBM Cutterhead in Mixed Rock Ground Conditions

Unified analysis method of removability and stability of rock blocks

Total loads modeling and geological adaptability analysis for mixed soil-rock tunnel boring machines

Dynamic Modeling of Gripper Type Hard Rock Tunnel Boring Machine

Analysis of face stability at the launch stage of shield or TBM tunnelling using a concrete box in complex urban environments

Study of Rock-Cutting Process by Disc Cutters in Mixed Ground based on Three-dimensional Particle Flow Model

Real-time perception of rock–machine interaction information in TBM tunnelling using muck image analysis

Evaluation of rock muck using image analysis and its application in the TBM tunneling

Experimental and numerical investigations on the force characteristics of cutter in different regions of the TBM cutterhead

Comparison of the Mechanical Performance Between Two-Stage and Flat-Face Cutter Head for the Rock Tunnel Boring Machine (TBM)

Mechanical Aspects of Construction of New TBM Tunnel Under Existing Structures

Mechanical Analysis of Rock Tunnels Reinforced by Grouted Rockbolts Considering the Blasting Damage Effect

Influence of vibration on the performance of tunnel boring machines