Abstract:Fuel injection is one of the most important processes in compression-ignition internal combustion engines owing to its significant impact on the exhaust emissions and thermal efficiency. In this study, experiments were carried out to investigate the influence of injection pressure and injection timing on the temporal evolution of the injection rate and injection duration in a specially designed experiment rig equipped with a common rail injection system. It is well known that the injection signal from the electronic control unit (ECU) of the injection system, which is often the only injection information available in engine operation and experiments, gives little information about the actual injection rate profile. It is shown in the present experiments that the actual injection duration is usually longer than the energizing time (ET). The time delay between the actual injection of the fuel and the ECU signal is about 0.3-0.4 ms, and the time delay appears to be insensitive to the injector geometry and injection pressure condition. The injection process can be characterized as five stages, a fast injector valve opening stage, a slow valve opening stage, a valve fully open stage, followed by a slow valve closing stage, and finally a rapid valve closing stage. It is found that the first stage, the fast valve opening stage, is insensitive to the injection pressure and injector nozzle diameter; however, the peak injection rate is a strong function of these parameters. The second and the third stage may not appear with a short injection duration. A new injection model was developed for the common rail injection system, which was capable of simulating the instantaneous fuel injection rate and injection duration for a range of injection pressure and injection duration. The model was shown to be able to replicate the experimental injection rate profile of the present experiments and experiments found in the literature for common rail injection system. The new injection model was applied to predict the effect of injection pressure and injection duration on the performance of a diesel engine under various engine speed and load conditions. The new injection model was shown to be able to describe the injection mass flow rate, which eventually leads to a reasonably good prediction of the variations of the spray development, in-cylinder pressure, heat release rate, and emissions.

Experimental Investigation of the Rail Pressure Fluctuations Correlated with Fuel Properties and Injection Settings

Experimental Study on the Two Stage Injection of Diesel and Gasoline Blends on a Common Rail Injection System

Investigation of fuel injection rate identification algorithm based on rail pressure fluctuation characteristics induced by injection

Effect of Rail Pressure on Spray Characteristics

An experimental study of gasoline effects on injection rate, momentum flux and spray characteristics using a common rail diesel injection system

Experimental and Numerical Investigation of Injection Timing and Rail Pressure Impact on Combustion Characteristics of a Diesel Engine

Experimental investigation on spray and atomization characteristics of diesel/gasoline/ethanol blends in high pressure common rail injection system

Experimental and Modeling Study of Liquid Fuel Injection and Combustion in Diesel Engines with a Common Rail Injection System

Effect of Injection Dynamic Behavior on Fuel Spray Penetration of Common-Rail Injector

Study of the Optimization of Rail Pressure Characteristics in the High-Pressure Common Rail Injection System for Diesel Engines Based on the Response Surface Methodology

Experimental Investigation on Effect of Gas/spray Interactions on Transient Diesel Spray Behaviors

Pressure Fluctuation Characteristics of High-Pressure Common Rail Fuel Injection System

The Influence of Nozzle Parameters on the Atomization Performance of Non-normal Fuel based on the Super-high Pressure Common Rail System

Experimental Investigation of the Orifice-to-orifice Variability in Jet Velocities in a Diesel Injector

A Numerical Study of the Effects of Pressure Fluctuations Inside Injection Nozzle on High-Pressure and Evaporating Diesel Spray Characteristics

Research of Rail Pressure Control Strategy on Common Rail Fuel System

Experimental Study of the Spray Characteristics of Diesohol Fuel using a High-Pressure Common-Rail Injection System in a Diesel Engine

Experimental Investigation on Liquid Length of Direct-Injection Ammonia Spray under Engine-Like Conditions

Combustion and Emission Characteristics of an Electronically-Controlled Common-Rail Dual-Fuel Engine

Gasoline spray characteristics using a high pressure common rail diesel injection system by the method of laser induced exciplex fluorescence

Research on the pressure fluctuations and hydraulic resonance phenomena in the high-pressure pipelines of marine common rail systems