Abstract:Abstract Per recent analyses, in the near future, over half amount of the oil extracted globally will require some form of enhanced oil recovery (EOR) technique. Existing literature and historical investigations suggest that in oil reservoirs having viscosities between 10 — 150 m. Pa.s, there is a substantial prospective for tertiary recovery through the implementation of polymer flooding. For reservoir oil viscosities above 150 mPa.s, the polymer pumping efficiency goes down as polymer injectivity reduces significantly with increasing injection water viscosity that is used to attain a favorable mobility ratio at such high oil viscosities. To overcome this limiting factor, in this study, we propose the use of supramolecular assemblies (SMA) that have adjustable viscosity properties. Complex long-chain amino-amides and maleic acid are used to make these assemblies, which allow it to have reversible viscosity depending on the solution pH level. To maintain high injection efficiency, during pumping, SMA solutions will be kept at low viscosity values. On entry in deep reservoir or at oil contact phase, through introduction of an external stimulus, the viscosity of SMA solution will be reversed to a much higher viscosity. This will allow to sufficiently improve the mobility ratio. Preliminary results from lab-scale studies have indicated that along with reversibly adjustable viscosity property, SMA solutions are also tolerant to high temperatures and salt concentrations. Supramolecular solutions can be contemplated as remedy polymer systems, since unlike conventional polymers they disassemble and re-assemble when exposed to high temperature and stress conditions. In such conditions, conventional polymers generally undergo degradation. Additionally, through molecular scission processes SMA solutions can also be used in highly confining environments as well as in permafrost conditions and thin zones where conventional thermal techniques are not applicable. The objective of this work is the development of a novel SMA system that has the aforementioned properties of reversibly adjustable viscosity through pH, tolerance to high temperature and salt concentrations through desired interfacial properties. Lab-scale preliminary results have shown the potential economic benefits of the use of SMA solutions on a field-wide scale. Based on the results, it must be emphasized that SMA systems have a worldwide application in oil reservoirs for EOR purposes.

The Effect of Polymer Type on the Performance of Gels

JIN Zhiyuan1,2, SHAN Guorong2,3, PAN Pengju2,3

Production Optimization under Injection of Biopolymer, Synthetic Polymer and Gels in a Heterogeneous Reservoir

Preparation Method and Performance Evaluation of a Gel Based on AM/AMPS Copolymer

Next-Generation Gelling Agents for Improved Displacement in Enhanced Oil Recovery Processes

Optimization of the Methods to Develop Stable Polymer Gels for Water Management in Medium- and Ultra-High-Salinity Reservoirs

Effect of AMPS(2-acrylamido-2-methylpropane sulfonic acid) content on the properties of polymer gels

Study on Water-Soluble Phenolic Resin Gels for High-Temperature and High-Salinity Oil Reservoir

Preparation of high-temperature gels for enhanced oil recovery using methyl etherized melamine-formaldehyde resin

Preparation and Performance Evaluation of Temperature-Resistant and Salt-Resistant Gels

Synthesis and properties of elevated temperature hydrogels for enhanced oil recovery based on AM/AMPA/NVP copolymer and silica nanoparticles

Syneresis Behavior of Polymer Gels Aged in Different Brines from Gelants

Study on long-term stability of polymer gel system under reservoir conditions

Probing the Effect and Mechanism of Flue Gas on the Performance of Resorcinol/Hexamethylenetetramine-Based Polymer Gel in Flue Gas Flooding Reservoir

Novel Gel with Controllable Strength for In-Depth Conformance Control: Bulk Gelation Performance and Propagation Properties in Porous Media

Experimental study of the hydroquinone (HQ)–hexamethylenetetramine (HMTA) gel system for conformance improvement in extremely high‐temperature reservoirs

Investigation of In Situ Gelation Behavior and Enhanced Oil Recovery Ability of Polymer Gel Used for Controlling CO2 Channeling in Tight Fractured Reservoir

Synthesis and Performance Evaluation of a Novel Heat and Salt-Resistant Gel Plugging Agent

APPLICATION PROGRESS OF INSITU POLYMER GEL IN OILFIELD CONFORMANCE CONTROL TREATMENT

Development and evaluation of organic/inorganic combined gel for conformance control in high temperature and high salinity reservoirs

Preparation and Characterization of Preformed Polyelectrolyte and Polyampholyte Gel Particles for Plugging of High-Permeability Porous Media