Abstract:Nitrogen is the most important cryogen in superconductivity. This study investigates the heat transfer characteristics of flow boiling in a horizontal macro-tube with an inner diameter of 10 mm, particularly focusing on flow boiling at negative gauge pressure. The experiments cover the following ranges: inlet pressure from −31.0 to 2.5 kPa, mass flux from 27.0 to 71.3 kg/(m 2 ·s), and heat flux from 0 to 28.68 kW/m 2 . The effects of operating parameters on the heat transfer coefficient (HTC) are examined, and the HTC data are compared with the predicted value from four correlations. At the bottom wall, the HTC distribution exhibits a "two-peak" shape. The primary peak is dominated by nucleate boiling in bubbly, plug, and slug flow with low vapor quality, while the secondary peak is dominated by convective evaporation with higher vapor quality. These two regions are roughly divided by the vapor quality of 0.3 to 0.4. In stratified flow, the HTC at the top wall is generally lower than that at the bottom. The HTC increases as the pressure decreases, particularly in the convective evaporation region. This is attributed to the high liquid–vapor density ratio, extensive thermal conductivity, and substantial surface tension at lower pressure. The effect of heat flux or mass flux on the HTC at the bottom wall differs between the nucleate boiling and convective evaporation regions. Increasing the heat flux improves the HTC where nucleate boiling dominates, while increasing the mass flux significantly improves convective evaporation, especially at higher heat flux. All selected correlations overestimate the HTC at the top wall. The Shah correlation demonstrates the best prediction accuracy for the HTC at the bottom wall, both at near atmospheric pressure (Mean Relative Error, MRE = 21 %) and at negative pressure (MRE = 19 %).

Experimental Study of the Heat Transfer Characteristics of Liquid Nitrogen in Narrow Channels

Experiment for influence of boiling surface on critical heat flux in liquid nitrogen pool boiling

Numerical simulation on pressure drop of slush nitrogen flow inside a horizontal pipe

Experiments and numerical simulation of dynamic cool-down process of stainless steel plate in liquid nitrogen bath

CFD Simulations and Experimental Verification on Nucleate Pool Boiling of Liquid Nitrogen

Study of Heat Transfer of Cryogenic Methane under Supercritical Pressure with Consideration of Thermal Conduction in Engine Cooling Channel Walls

Numerical Study of Conjugate Heat Transfer of Cryogenic Methane in Rectangular Engine Cooling Channels at Supercritical Pressures

Study on Convective Heat Transfer of Supercritical Nitrogen in a Vertical Tube for Liquid Air Energy Storage

An experimental study of heat transfer characteristics of capillary porous media in liquid nitrogen

Supercritical Heat Transfer of Cryogenic-Propellant Methane in Rectangular Engine Cooling Channels

Measurement of Boiling Heat Transfer Coefficient in Liquid Nitrogen Bath by Inverse Heat Conduction Method

Natural convective boiling in vertical rectangular narrow channels

Heat Transfer Enhancement of Supercritical Nitrogen Flowing Downward in a Small Vertical Tube: Evaluation of System Parameter Effects

Numerical study on convective heat transfer characteristics of supercritical nitrogen in a helical cruciform tube

Numerical Modeling for the Flow and Heat Transfer of Slush Nitrogen in a Horizontal Pipe Based on Population Balance Equations

Experimental study on heat transfer characteristics of liquid nitrogen through coated transfer line

Experimental Investigation of Liquid Metal Alloy Based Mini-Channel Heat Exchanger for High Power Electronic Devices

Flow boiling of liquid nitrogen in a horizontal macro-tube at low pressure: Part II – Heat transfer characteristics

Experimental Study on Local Subcooled Flow Boiling Heat Transfer in A Vertical Mini-Gap Channel

Experimental Study on Heat Transfer Characteristics of Two-Phase Flow in Square and Rectangular Channels

Experimental and Numerical Analysis on Heat Transfer Performance of Slug Flow in Rectangular Microchannel