Abstract:Effects of alkali metal halides (NaX, X = F(-), Cl(-), Br(-), I(-); KX, X = Cl(-), Br(-), I(-); and CsCl) on the morphology of the aggregates of decyltriethylammonium bromide and sodium decylsulfonate (C(10)NE-C(10)SO(3)) mixtures with equimolar ratios were studied by static/dynamic light scattering and viscosity measurements. The average hydrodynamic radii of the aggregates, the apparent aggregation number, and the relative viscosity as functions of both the concentrations of surfactants and added salts were investigated, respectively. It showed that the addition of a small amount of NaX (e. g., 0.1 M) had only small effects on the C(10)NE-C(10)SO(3) vesicles. However, striking anion specificity, which differed anomalously with the anions of salts varying from F(-) to I(-), was observed when large amounts of NaX (e. g., 1 M) were added. The size of the C(10)NE-C(10)SO(3) aggregates was normally increased and then a liquid-liquid phase separation occurred with the addition of NaF; meanwhile, the addition of NaCl had little effect on the C(10)NE-C(10)SO(3) aggregates under experimental conditions; however, the size of the C(10)NE-C(10)SO(3) aggregates was abnormally decreased when high concentrations of NaBr or NaI (up to 2 M) were added, implying a vesicle-to-micelle transition which might be due to a decrease in the intramicellar attraction between oppositely charged headgroups by electrical shielding, and the mixtures still remained homogeneous. A cation specificity of added salts was also observed with the increase of the ionic radii from Na(+) to Cs(+). However, it was noted that the influence of increasing the ionic radii of cations on the aggregate size was not as pronounced as that of anions in the presence of high concentrations of salts. The aggregates of C(10)NE-C(10)SO(3) became a little smaller when concentrated alkali metal halides with bigger cations were added into this homogeneous equimolar cationic-anionic surfactant mixture. Both the observed cation and anion specificities were consistent with the Hofmeister series.

Study On Stability Of Agcl Nanoparticles In F127 Microemulsion And Agcl/F127-Pmma Organic/Inorganic Hybrid Membranes

Micellization of PAA-F108-PAA Block Copolymer Using NMR Spectroscopy

A NOVEL NANOFILTRATION MEMBRANE PREPARED WITH PAMAM AND TMC (I)

Development of AgCl/poly(MMA-co-AM) Hybrid Pervaporation Membranes Containing AgCl Nanoparticles Through Synthesis of Ionic Liquid Microemulsions

Molecular dynamics study of the effect of inorganic salts on the monolayer of four surfactants at the oil/water interface

Effect of Hydrophobically Modified Polymer on Salt-Induced Structural Transition in Microemulsions

Synthesis and Characterization of Nano-silica/Polyacrylate Composite Emulsions by Sol-gel Method and In-Situ Emulsion Polymerization

Synthesis of a chitosan-clay nanomembrane by pH control and its thermal stability in aqueous environments

Nanostructures and multi-scale aggregation of high ion exchange capacity short-side-chain perfluorosulfonic acid dispersion

STUDY ON THERMO-SENSITIVE AMPHIPHILIC COPOLYMERS FROM N-ISOPROPYLACRYLAMIDE AND CHOLESTERYL ACRYLATE

Influence of NaCl on the Oil/water Interfacial and Emulsifying Properties of Walnut Protein-Xanthan Gum

Study on nano-size PMMA particles prepared by O/W microemulsion polymerization. - (1) Phase diagram, compatibilization and reaction kinetics

Anomalous Effects of Concentrated Salts on the Equimolarly Mixed Cationic–anionic Surfactant Mixtures

Preparation and Characterization of Solid Lipid Microparticles with Liquid Crystal Structure

Nanoemulsion stability above the critical micelle concentration: A contest between solubilization, flocculation and Krafft precipitation

Effect of surfactants on the interfacial behaviors of diacylglycerol-based solid lipid nanoparticles and physical stability of W/O emulsion

Rendering Hydrophobic Nanoclusters Water-Soluble And Biocompatible

Stability of Nano-Al_2O_3 Sol and Properties of PVDF/Al_2O_3 Hybrid Membrane

Influence of Salts on Morphology of Structures in Surfactant-Polymer Solutions Explored by Coarse Grained Dynamic Simulation

Preparation and Performance Evaluation of Self-Cementing Nanoscale Polymeric Microspheres with Salt and Temperature Tolerance

Preparation and Characterization of PSf/clay Nanocomposite Membranes with PEG 400 As a Pore Forming Additive