Abstract:High-strength bolted connections have attracted increasing attention over the past few decades because they can safely transfer the design load. However, the effect of the preload loss on the mechanical behavior of the bolted connections has not been investigated sufficiently, This paper presents an experimental investigation of the bearing capacity of high-strength bolted connections with loose bolts (lacking pretension force). The tests investigated ninety specimens with loose bolts and six specimens without loose bolts for comparison. The results showed that bolt fracture was the only failure mode for all of the tested connections under uniaxial tension. The global behavior of the tested connections exhibited four stages, and the features of each stage were summarized. The connections with different tightening conditions exhibited a similar trend in terms of strain development around the bolt holes. The effect of the slip coefficient, position and number of loose bolts, and the plate thickness is elucidated through parametric studies. It is found that the yield load of high-strength bolted connections may be affected by the pretension force and the slip coefficient, while the effect of the slip coefficient gradually decreases with the increasing number of loose bolts. The experimental results are compared to the calculated ultimate bearing resistance according to the GB 50017, Eurocode 3, and AISC 360-16 standards. It is found that the resistance prediction of the standards may be too conservative for the prediction of the ultimate bearing capacity of loose high-strength bolted connections when bolt fracture governs failure. Practical design recommendations in the algebraic form are presented and verified to predict the yield load and ultimate bearing capacity of loose high-strength bolted connections.

Effect Factors Study On The Pin Load Distribution Of Multi-Countersunk Bolt Composite Laminate Joints

Effect of Interference Fit Size on Local Stress in Single Lap Bolted Joints

Strengthening of Composite T-joints Using Ø 0.11 Mm Z-pins Via an Ultrasound-Guided Insertion Process

Influence of Interference Fit Size on Hole Deformation and Residual Stress in Hi-Lock Bolt Insertion

Mechanical Behavior of Loose High-Strength Bolted Connections with Thin Sheet Steels

Experimental and Numerical Analyses of the Shimming Effect on Bolted Joints with Nonuniform Gaps

Effect of Ø 0.11 Mm Z-pinning on the Properties of Composite Laminates Via an Ultrasound Guided Insertion Process

Influence of Design Parameters on Mechanical Behavior of Multi-Bolt, Countersunk C/SiC Composite Joint Structure

Bearing failure and strengthening mechanism of countersunk thin-ply laminated joints using an interference-fit bolt

An improved 3D model of composite bolted joints with detailed thread structure and progressive damage analysis of realistic tightening process

The effects of countersink depth on fatigue performance of CFRP joint

An improved 2D finite element model for bolt load distribution analysis of composite multi-bolt single-lap joints

A detailed experimental parametric analysis of bolted and hybrid bolted/bonded composite joints

Investigation on the Progressive Damage and Bearing Failure Behavior of Composite Laminated Bolted Joints under Tension

An Even-Load-distribution Design for Composite Bolted Joints Using a Novel Circuit Model and Neural Network

Parametric study on the load-carrying capacity of plain-woven composites hybrid bonded-bolted joints

Analysis and determination of bolt tightening process factors for composite structures under multiple working conditions

Effects of structural parameters on the load distribution unevenness in CFRP hybrid bonded‐bolted joint

An even-load-distribution design for composite bolted joints using a novel circuit model and artificial neural networks

Research on the relationship between the tightening torque and the preload of composite bolted structures

Effect of Gap and Shims on the Strain and Stress State of the Composite-Aluminum Hybrid Bolted Structure