Abstract:The present study investigates pulverized coal combustion under oxy-fuel conditions interacting with turbulent boundary layer flows over a flat plate using direct numerical simulation (DNS). The coal particles are tracked in the Lagrangian framework while the flow is solved in an Eulerian way. Three cases with reacting particles, inert particles and single-phase flows were performed. The interplay between pulverized coal combustion, turbulent boundary layer flows and the wall was examined. It was shown that the coal particles first ignite in the outer layer of the boundary layer turbulence, where individual coal particle ignition occurs. The wall-normal velocity in the reacting case is larger compared with that of the non-reacting cases due to flow acceleration induced by combustion. The volatile matter mass fraction is high in the inner layer in the downstream region. However, the heat release rate is low due to the cold wall effect. The strong correlation between the wall heat flux and streak structures in the near-wall region is observed in all cases. The values of radiative heat transfer are similar in the upstream region of both the cases with reacting and inert particles. However, as combustion occurs and particle temperature increases in the reacting case, the radiative heat transfer from particles to the wall increases significantly in the downstream region. Particle accumulation due to turbophoresis in the near-wall region is analyzed. It was shown that the magnitude of streamwise vorticity is attenuated by coal combustion. Therefore, particle wall-accumulation is less prominent in the reacting case compared with the inert case.

Experimental Research And Numerical Simulation Of Wall Temperature Influence On Multi-Stage Pulverized Coal Ignition

RESEARCHES ON THE IGNITION REGULATION OF THE PULVERIZED COAL-AIR FLOW IN A TUBE

OXYGEN-ENRICHED COMBUSTION IN A HORIZONTAL FURNACE AND THREE- DIMENTIONAL NUMERICAL SIMULATION TEST THEREOF

EXPERIMENTAL STUDY OF EFFECT OF PULVERIZED COAL CONCENTRATION ON COAL IGNITION WITH HOT WALL

EXPERIMENTAL STUDY AND NUMERICAL SIMULATION OF TWO-STAGE OIL-LESS IGNITION SYSTEM

Investigations into the Ignition Behaviors of Pulverized Coals and Coal Blends in a Drop Tube Furnace Using Flame Monitoring Techniques

Numerical Simulation of Pulverized Coal Mixing in the Second-stage of a Multi-stage Oil-less Ignition System

Experimental Study on High Temperature Air Multistage Ignition Combustor

Study on experiments and numerical simulation of coal combustion characteristics under different thermal environments

Experimental and Numerical Study on Temperature Variation and Air Flow Distribution in Trapped Votex Combustor

Experiment Research on Combustion of Microwave Modified Pc

Numerical Simulation on the Rich/Lean Pulverized Coal Burner

Numerical Investigation of Different Burner Arrangement on A Coal-Fired Boiler

NUMERICAL SIMULATION OF OIL-FREE IGNITION COMBUSTOR

Numerical Simulation of Combustion in 35 t/h Industrial Pulverized Coal Furnace with Burners Arranged on Front Wall

Numerical and experimental investigations on the performance of a 300 MW pulverized coal furnace

Numerical Simulation Of The Combustion Processes In A W-Shaped Boiler Furnace Under Different Operating Conditions

Pulverized Coal Combustion in Boundary Layer Turbulence Using Direct Numerical Simulation

Experiment and Modeling of the Ignition of Coal Particles in the Chamber

Experimental and theoretical analyses on ignition and surface temperature of dispersed coal particles in O2/N2 and O2/CO2 ambients

Numerical Analysis for Coal Gasification Performance in a Lab-Scale Gasifier: Effects of the Wall Temperature and Oxygen/Coal Ratio