Abstract:At present, the most prominent technical problems of small and medium capacity expanders are low internal efficiency and small expansion ratio. In order to promote the practical application of small and medium capacity Organic Rankine Cycle (ORC) system, improving the thermodynamic performance of the expander was a remarkable issue, and the systematic research on the irreversibility of expander's working process is the fundamental work to achieve this goal. Summarizing the related research on various small capacity volumetric expanders, the research on flow problem is lacked. For an atypical volumetric expander, the flow mechanism of single screw expanders (SSEs) is more complex. In this paper, we discussed the effect of the pressure loss in the inlet and exhaust passages on the performance of SSEs. We selected two SSE prototypes developed by our laboratory to carry out the experiment under variable working conditions. The internal volume ratios are 2.95 and 3.98 respectively. The pressure differences of inlet and exhaust passages were measured. In order to evaluate the effect of the flow losses on the performance, we defined two indexes: pressure loss rate (PLR) and pressure energy loss influence rate of shaft efficiency (PELRe). From the results, the pressure losses of inlet and exhaust passages for each SSE increase gradually, PLRin increases slightly and PLRout increases gradually. At the maximum point of shaft efficiency, the losses of the SSE with 2.95 are 28.06 kPa and 46.09 kPa, and the values of the SSE with 3.98 are 37.58 kPa and 33.79 kPa, respectively. It shows that the pressure losses are relatively high. The maximum values of internal and external expansion ratio for the SSE with 2.95 are 4.8 and 6 respectively, and the values of the SSE with 3.98 are 5.7 and 7 respectively. For ideal volume expansion, the internal expansion ratio of two prototypes should be 4.55 and 6.9, respectively. Summarizing the above results, how to enhance the pressure drop effect of leakage and reduce the flow resistance loss of inlet and exhaust passages simultaneously is an important technical premise to improve the expansion ratio by structural optimization. Meanwhile, PELRe of two prototypes are 16.01% and 13.59% respectively at the point. It shows that the flow losses of inlet and exhaust passages could significantly influence the performance of SSEs.

Analysis of the Thermodynamic Disequilibrium Loss of the Two-Phase Expansion Process and Its Influence on the Performance of a Reciprocating Expander

Analysis of the Intake Process and Its Influence on the Performance of a Two-Phase Reciprocating Expander

Study on Thermodynamic Process of Two-Phase Screw Expander

Influence of Evaporating Rate on Two-Phase Expansion in the Piston Expander with Cyclone Separator

Experimental Study of Equivalent Expansion Inside Two-Phase Expanders

Advanced Exergy Analyses of an Ejector Expansion Transcritical Co2 Refrigeration System

Modeling and performance analysis of twin-screw steam expander under fluctuating operating conditions in steam pipeline pressure energy recovery applications

Study of A Rotary Vane Expander for the Transcritical Co2 Cycle-Part I: Experimental Investigation

Experimental Study of Heat Transfer Characteristics among the Two-Phase Expansion Process

Study of a Rotary Vane Expander for the Transcritical CO 2 Cycle—Part II: Theoretical Modeling

Thermodynamic Simulation On The Performance Of Twin Screw Expander Applied In Geothermal Power Generation

Performance Improvement of Twin-Screw Air Expander Used in PEMFC Systems by Two-Phase Expansion

Numerical Study on Two-Phase Expansion Performance and Quantitative Analysis of Wetness Loss in Cryogenic Turbo-Expander

Investigation of the Compression and Expansion Process for Reciprocating Compressor

Characteristics study of non-equilibrium flash for two-phase expansion based on equivalent expansion experiments

Dynamic Simulation of an Improved Transcritical Co2 Ejector Expansion Refrigeration Cycle

Experimental investigation on the internal working process of a CO2 rotary vane expander

Development of a double acting free piston expander for power recovery in transcritical CO2 cycle

Experimental study on the influence of inlet and exhaust pressure loss on the performance of single screw expanders

Experimental Investigation on the Thermodynamic Performance of a Rotary Vane Expander in the Air System

Comparison between modeling and experiments on a two-stage rotary vane expander for an HFC-410A air conditioning system