Abstract:In this present work, we applied Taguchi’s plan of experimentation as a numerical tool to develop a TiO2 gas sensor. This plan permits us to reduce the number of experimentations and obtain the optimal conditions of factors involved in the development of the sensitive layer. The focal concept is to optimize the TiO2 thin film conductivity by using an L9 (33) orthogonal array based on three important factors of spray pyrolysis deposition (A, concentration of [Ti4+]; B, deposition temperature; and C, spray pyrolysis time). These factors are varied to select the best deposition conditions and to obtain the best conductivity of TiO2 thin films. From the calculation of signal-to-nose ratio (S/N) and the analysis of variance (ANOVA) based on the conductivity values of thin films, the optimal combination of factors is A2B3C3, which corresponds to the concentration [Ti4+] = 0.3 kmol/m3, the deposition temperature T = 500°C and the spray time = 15 min. The validation test confirmed that this combination of deposition parameters is the most optimal to improve the most important TiO2 thin film properties. X-ray diffraction shows a high privileged direction along the (101) plane, large crystallite size of 21.43 nm and low dislocation density of 2.17 × 10−3 nm−2. The Raman modes located at 143 cm−1, 391 cm−1, 512 cm−1 and 633 cm−1 confirmed the purity of anatase TiO2. The images of scanning electron microscopy showed the growth of compact and granular film with an average of grain size of 66.76 nm. The optical analysis showed a transparent semiconductor with large band gap of 3.33 eV. The electrical measurement displayed a good conductivity of TiO2 equal to 280.06 × 10−6 (S m−1). These outcome properties make TiO2 thin film an attractive material for gas sensor applications.

Study On Design And Properties Of Paper-Based Nano-Sized Tio(2) Gas Sensor

Synthesis of flowerlike nano-SnO2 and a study of its gas sensing response

Fabrication and design of a toxic gas sensor based on polyaniline/titanium dioxide nanocomposite film by layer-by-layer self-assembly

Development of a gas sensor utilizing chemiluminescence on nanosized titanium dioxide.

The Challenges and Opportunities for TiO2 Nanostructures in Gas Sensing

Preparation and Gas Sensitivities of Monoclinic TiO2

TiO2-Based Nanoheterostructures for Promoting Gas Sensitivity Performance: Designs, Developments, and Prospects

TiO2 Gas Sensors Combining Experimental and DFT Calculations: A Review

Fully Flexible MXene-based Gas Sensor on Paper for Highly Sensitive Room-Temperature Nitrogen Dioxide Detection.

Gas Sensing Characteristics of Nano-Structured Metal Oxides

Synthesis and Characterization of TiO2 Nanotubes for High-Performance Gas Sensor Applications

Fabrication of a Sensitive Gas Sensor Based on PPy/TiO2 Nanocomposites Films by Layer-by-layer Self-Assembly and Its Application in Food Storage

Preparation and Gas-Sensing Properties of Nano-Cotio3

Optimization with Taguchi Approach to Prepare Pure TiO2 Thin Films for Future Gas Sensor Application

Investigations on TiO2–NiO@In2O3 nanocomposite thin films (NCTFs) for gas sensing: synthesis, physical characterization, and detection of NO2 and H2S gas sensors

Nanostructured Mesoporous Tungsten Oxide for Gas Sensor Applications

Quantum Confinement and End-Sealing Effects for Highly Sensitive and Stable Nitrogen Dioxide Detection: Homogeneous Integration of Ti3C2Tx-Based Flexible Gas Sensors

Gas Sensing Capabilities of Tio2 Porous Nanoceramics Prepared Through Premature Sintering

Preparation and gas-sensing performance under photoactivation of TiO2 nanotubes/carbon nanotubes/ZnS quantum dots gas-sensitive materials

Toward Practical Gas Sensing with Rapid Recovery Semiconducting Carbon Nanotube Film Sensors

Formation of Highly Porous Gas-sensing Films by In-situ Thermophoretic Deposition of Nanoparticles from Aerosol Phase