Abstract:Surface texturing technology is a novel avenue for enhancing gas foil bearing performance. For the cases of heavily loaded foil bearing, the static equilibrium eccentricity ratio may exceed 1.0, even 4.0, which will result in poor convergence for the numerical algorithm. The introduction of textures and numerical calculations under heavy load conditions have heightened the complexity of the solution, and the multigrid method offers an efficient resolution to this challenge. This paper established the pressure governing equation considering the effects of gas rarefaction. The cumulative eccentricity method was applied to analyze the bearing’s behavior under heavy-load operating conditions. Additionally, the numerical solution efficiency of the direct, iterative, and multigrid methods was analyzed. Furthermore, the Newton-Raphson method and the perturbation method are utilized to determine the static and dynamic characteristics under large eccentricity conditions. The results indicate that the multigrid method offers up to a 77% increase in computational efficiency compared to the direct solution method. The bearing exhibits maximum load capacity when the axial texture ratio is above 0.7 and the circumferential texture ratio is within the range of 0.3 to 0.4. As the eccentricity ratio increases from 0.1 to 4, the enhancing effect of surface texturing on load capacity decreases by 6.78%, while the friction-reduction effect increases by 4.25%. Furthermore, critical mass calculations indicate improved bearing stability with a large eccentricity. This study shows that suitable texture parameters effectively improve the bearing performance under heavy-load conditions, while the multigrid method can efficiently solve the above problems.

Optimization And Simulation Of Self-Acting Gas Bearing Rectangular Groove Section

Optimization Of No-Whirl-Wind Self-Acting Gas Bearing Groove Shape

Effect of T-groove Parameters on Steady-State Characteristics of Cylindrical Gas Seal

Study on Dynamic Pressure Effect of Gas Bearings in Fuel Cell Vehicles

The Influence of Groove Types on Air Bearing Properties

Studying on the characteristics of axial-grooved gas-lubricated cylindrical bearing

Influences of Pressure-equalizing Groove on the Load Capacity of Externally Pressurized Gas Journal Bearings

New Numerical Solution for Self-Acting Gas Journal Bearings

Numerical Optimization of the Groove Texture Bottom Profile for Thrust Bearings

Improvement on load performance of externally pressurized gas journal bearings by opening pressure-equalizing grooves

Performance of Heavily Loaded Textured Gas Foil Bearings Based on the Multigrid Method

Numerical Analysis of Spiral Grooved Opposed-Hemisphere Gas Bearings: A Parametric Study

Optimization of Groove Texture Profile to Improve Hydrodynamic Lubrication Performance: Theory and Experiments

Research on the Reciprocating Load Characteristics of a Hydrodynamic Bearing Surface with Sloped Grooves

Prediction of spiral groove dry gas seal performance and intelligent optimization of structural parameters

Analysis of static and dynamic characteristics of spiral-grooved gas journal bearings in high speed

Simulation of micro scale gas bearings with dense gas effect

Effect of herringbone groove structure parameters on the static performance of gas foil herringbone groove thrust bearings

Three-dimensional Calculation Method of Bearing Capacity for Externally Pressurized Spherical Gas Bearings

Performance Research on the Externally Pressurized Gas Journal Bearing under Different Working Gas Based on Finite Difference Method

Modelling and performance improvement of an annular grooved thrust air bearing