Comparison Of Time-Dependent Variation Of Surface Charge Accumulation In Sf6/N-2 And Pure Sf6

Han Wang,Jian-Yi Xue,Bao-Hong Guo,Jun-Bo Deng,Guan-Jun Zhang

DOI: https://doi.org/10.1109/icpadm.2018.8401232

2018-01-01

Abstract:SF6/N-2 Mixture has good insulation properties and reduces the use of SF6, thus it has drawn more and more attention. In addition, Surface charge accumulation on insulating materials is a major factor that greatly distorts the electrical field and reduces the insulation level. Therefore, it is necessary to research the characteristics of surface charge accumulation in SF6/N-2 mixture. In this paper, the difference between the time-dependent variation of surface accumulated charge of spacer in 5atm pure SF6 and that in 5atm 20% SF6/N-2 is researched. The downsized truncated cone-type spacer made of 70% Al2O3 filled epoxy resin and coaxial cylinder electrodes are used to model a GIL. In the experiment, +/- 30kV and +/- 40kV DC voltage are applied to the central electrode for 30-1080 min, then the surface potential of spacer is measured by a Kelvin vibrating electrostatic probe, and the corresponding surface charge density is further calculated by a calibration method. The results reveal that in both gases, the surface accumulated charge exhibits a time dependent variation characteristic that the local fluctuates and the whole tends to saturate. Under the DC voltage of same amplitude and same applied time, the total amount of surface charge in 20% SF6/N-2 is far more than that in pure SF6. However, the maximum of surface charge density in 20% SF6/N-2 is not much different from that in pure SF6 under the same condition of DC voltage. Moreover, in pure SF6, the total amount of surface charge under negative DC voltage is far more than that under positive DC voltage, which means there is polar effect in pure SF6. However, in 20% SF6/N-2 the polar effect does not exist.