Abstract:Commercially available low-cost particulate matter (PM) sensors provide output as total or size-specific particle counts and mass concentrations. These quantities are not measured directly but are estimated by the original equipment manufacturers' (OEM) proprietary algorithms and have inherent limitations since particle scattering depends on their composition, size, shape, and complex index of refraction (CRI). Hence, there is a need to characterize and calibrate their performance under a controlled environment. We present calibration algorithms for Plantower PMS A003 sensor as a function of particle size and concentration. A standardized experimental protocol was used to control the PM level, environmental conditions and to evaluate sensor-to-sensor reproducibility. The calibration was based on tests when PMS A003 were exposed to different polydisperse standardized testing aerosols. The results suggested particle size distribution from PMS A003 was shifted compared to reference instrument measures. For calibration of number concentration, linear model without adjusting aerosol properties corrects the raw PMS A003 measurement for specific size bins with normalized mean absolute error within 4.0% of the reference instrument. Although the Bayesian Information Criterion suggests that models adjusting for particle optical properties and relative humidity are technically superior, they should be used with caution as the particle properties used in fitting were within a narrow range for challenge aerosols. The calibration models adjusted for particle CRI and density account for non-linearity in the OEM's mass concentrations estimates and demonstrated lower error. These results have significant implications for using PMS A003 in high concentration environments, including indoor air quality and occupational/industrial exposure assessments, wildfire smoke, or near-source monitoring scenarios.

Intelligent Calibration Of Laser Particle Size Analyzer

A Three-dimension High-Precision and Non-contact Dynamic Angular Displacement Measurement System based on Heterodyne Interference

High-precision laser alignment technique based on spiral phase plate

Calibration of the fast scan multichannel spectrometer

Calibration of a Multi-Beam LIDAR by Using Linear Instrumental Error Model

Intelligent Measuring System for Performance Parameters of Laser Range Finder

Optimization of System Design and Calibration Algorithm for SPAD-Based LiDAR Imager

Calibration of Laser Beam-Direction for Point Laser Sensors

Calibration for the Errors Resulted from Aberration in Long Focal Length Measurement

Calibration of a Single-Point Laser Range Finder and a Camera

Distance Measuring Using Single-Point Laser Triangulation System Design Based on CMOS

High-accuracy calibration for multi-laser powder bed fusion via in situ detection and parameter identification

Accuracy calibration of the multi-light screen measurement system using array optical signal

Calibration technology and application of laser power meter

Calibration of the laser displacement sensor and integration of on-site scanned points

Performance calibration of low-cost and portable particular matter (PM) sensors

Assessing the Value of Complex Refractive Index and Particle Density for Calibration of Low-Cost Particle Matter Sensor for Size-Resolved Particle Count and PM2.5 Measurements

A Method to Calibrate Accelerometers by Laser Self-Mixing Self-Traceable Grating Interferometry

A novel approach on calibration calibration of a laser line sensor's position in the machine coordinate system

LMS-based calibration of pipelined ADCs including linear and nonlinear errors

Design and calibration of a rotating laser transmitter for fast and high-precision laser self-levelling system