Abstract:Piles supporting transmission towers, offshore structures (such as wind turbines), or infrastructures in seismic areas are frequently subjected to either one-way or two-way cyclic lateral loadings. Relatively little attention, however, has been paid to compare and understand the effects of different loading regimes (one-way or two-way cycling) on lateral responses of piles in soft clay. For this reason, a series of field tests in soft clay are carried out to compare one-way and two-way cyclic responses of single piles and of jet-grouting reinforced piles. The field tests reveal that the single pile subjected to two-way cycling experiences much more rapid degradation in lateral stiffness and capacity, but accumulates much smaller residual pile deflection (δ p), than the single pile under one-way cycling. This is because the reverse part of the two-way cycling also generates plastic strain, causing additional softening and strength reduction in the soil surrounding the pile. After each cycling, non-zero bending moment (i.e. locked in moment, or M L) is retained in the single piles, and the M L increases with the δ p. The one-way cycling leads to two times larger M L than the two-way cycling, as it causes greater δ p. The maximum M L in the pile after one-way cycling can be up to 40% of the maximum bending moment induced during the previous cyclic loading stage. After application of jet-grouting surrounding the upper part of the single pile, it greatly reduces degradation of lateral pile stiffness, accumulation of δ p and therefore development of M L. Compared to the field measurements, the API (API RP 2A-WSD, recommended practice for planning, designing, and constructing fixed offshore platform-working stress design, 21st edn. API, Washington, 2000) code underestimates the lateral stiffness of the pile under one-way cycling, while overestimates that of the pile under two-way cycling, leading to a non-conservative prediction of bending moment in the latter pile.

Driveability Study Of Open-Ended Steel Pipe Piles In Soft Soils

Field Tests of Offshore Driven Piles Subjected to Lateral Monotonic and Cyclic Loads in Soft Clay

MPM Modeling of Pile Installation in Sand: Contact Improvement and Quantitative Analysis

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

Model Tests on the Bearing Capacity of Precast Open-Ended Micro Pipe Piles in Soft Soil

Field Trials on Monotonic Behaviour of a Driven Pile at an Offshore Wind Farm in China

Model tests on the bearing capacity of precast oxen-ended micro pipe plies in sort soil

Theoretical study of dynamic pore water pressure dissipation characteristics of open-hole pipe pile

Response of Open-End Pipe Piles to Vertical Dynamic Load Considering the Effects of Soil Plug and Soil Disturbance During Driving

Effect of Loading Rate on Lateral Pile-Soil Interaction in Sand Considering Partially Drained Condition

Dynamic Response of Offshore Open-Ended Pile under Lateral Cyclic Loadings

3-D Numerical Simulation for Large-Diameter Cast-<i>In Situ</i> Tubular Pile

Load Transfer of Offshore Open-Ended Pipe Piles Considering the Effect of Soil Plugging

Field Testing of One-Way and Two-Way Cyclic Lateral Responses of Single and Jet-Grouting Reinforced Piles in Soft Clay

Studies on Bearing Characteristic of Open-Ended and Close-Ended Pipe Piles under High-Speed Railway Loadings

Dynamic Analysis Model of Open-Ended Pipe Piles That Considers Soil Plug Slippage

A Field Study on the Behavior of Static Drill Rooted Nodular Piles with Caps under Compression

Field and Numerical Study of the Lateral Response of Rigid Piles in Sand

A Simplified Nonlinear Calculation Method to Describe the Settlement of Pre-Bored Grouting Planted Nodular Piles

Field Tests and Simplified Calculation Method for Static Drill Rooted Nodular Pile

Failure analyses of open-ended pre-stressed high-strength concrete pile during driving: insights from distributed fiber optic sensing