Abstract:Landfill leachate sludge (LLS), originated from the infiltration of rainwater through dumping sites of waste and water contained in landfills, is a specific type of sewage. Since its large amount, environmental unfriendliness and compositional instability, the sustainable management and disposal of LLS requires urgent attention. In this study, LLS disposal problem was addressed along with the removal of chromium (Cr) from water. Firstly, the thermal behaviors of LLS were investigated through TG analysis. Secondly, LLS-based biochar (SC) was prepared in a tubular furnace, and the effect of pyrolysis temperature on the yield and properties of SC was investigated. Finally, using SC900 as Cr(VI) adsorbent, the influence of various factors on Cr(VI) adsorption were investigated. BET, FTIR, and XPS analyses were performed to determine the characteristics of SC and the variation of SC before and after adsorption. Results showed that, TG curve of LLS exhibited a rapid mass loss of 54.15% between 220 and 525 °C due to the cleavage of C-O and C-C bonds with the release of large amounts of CO2. The SC yields were in the range of 10.81–22.16% when the pyrolysis temperature ranged from 400° to 900°C. The optimal pyrolysis temperature for the preparation of the SCs was determined to be 900 °C, and SC900 had a relatively high BET surface area of 83.87 m2/g. exhibited the highest Cr(VI) adsorption of 17.46 mg/g. The main oxygen-containing functional groups (-OH, C-O, CO) present in the SC played an important role to adsorbed Cr(VI) and reduced it to Cr(III) at a low pH. As a result, 76.5–85.3% of the adsorbed Cr(VI) was reduced to the less toxic Cr(III). Moreover, only 0.52% (1.56 ppm) of the adsorbed Cr (from a 300 ppm solution) leached from SC900, which indicated the high stability of the adsorbed Cr in the SC.

Pyrolysing Wood Into Carbons For Cr(Vi) Adsorption: Performances Compared To Mineral Adsorbents

INTENSIFICATION OF ADSORPTION PROCESS BY USING THE PYROLYTIC CHAR FROM WASTE TIRES TO REMOVE CHROMIUM(VI) FROM WASTEWATER

Leaf char: An alternative adsorbent for Cr(III)

Adsorption-catalytic Mechanism for Pyrolytic Carbon Black from Waste Tires on Cr(Ⅵ) in Aqueous Solution

Biochar Pyrolytically Produced from Municipal Solid Wastes for Aqueous As(V) Removal: Adsorption Property and Its Improvement with Koh Activation

Study on the co-pyrolysis behaviors of sewage sludge and Enteromorpha prolifera and the adsorption mechanism of Cr(VI) in water using pyrolysis residue

Synergistic effects of pyrolysis temperature, iron ion concentration and solid/liquid ratio on the properties and Cr(VI) removal performance of magnetic carbon

Characteristics and adsorption of Cr(VI) of biochar pyrolyzed from landfill leachate sludge

Fabrication of Carbon–Alumina Composites via Catalytic Pyrolysis of Pine Sawdust on Aluminum Dross for Cr(VI) Removal

Versatile Strategy for the Preparation of Woody Biochar with Oxygen-Rich Groups and Enhanced Porosity for Highly Efficient Cr(VI) Removal

Pyrolysis temperature and feedstock affected Cr(VI) removal capacity of sulfidated zerovalent iron: Importance of surface area and electrical conductivity

Cr(VI) adsorption performance and mechanism of an effective activated carbon prepared from bagasse with a one-step pyrolysis and ZnCl2 activation method

Aqueous Cr(VI) removal by biochar derived from waste mangosteen shells: Role of pyrolysis and modification on its absorption process

The co-pyrolysis of waste urea–formaldehyde resin with pine sawdust: co-pyrolysis behavior, pyrocarbon and its adsorption performance for Cr (VI)

Insights into Cr(VI) removal mechanism in water by facile one-step pyrolysis prepared coal gangue-biochar composite

Investigation of black liquor-derived carbon for removal of Cr(VI): Comparison with lignin-derived carbon

Biomass Cellulose Component and Fe Mineral Catalysis Help Cr(VI) to Realize Almost 100% Pyrolysis Reduction Efficiency

Study on the Co-pyrolysis Behavior of Copper Slag and Pine Sawdust and the Adsorption of Chromium

The ultramicropore biochar derived from waste distiller's grains for wet-process phosphoric acid purification: Removal performance and mechanisms of Cr(VI)

A functionalized activated carbon adsorbent prepared from waste amidoxime resin by modifying with H3PO4 and ZnCl2 and its excellent Cr(VI) adsorption

ADSORPTION OF Cr (VI) FROM AQUEOUS SOLUTION BY SLUDGE-BASE ACTIVATED CARBONS OBTAINED FROM CHEMICAL AND PHYSICAL ACTIVATION