Abstract:One promising solution for future large wind turbine power conversion is to use medium-voltage power conversion systems for high efficiency and high power-density, e.g., by using a cascaded structure presented in this paper. However, a medium-frequency (MF) oscillation issue was observed while testing the experimental prototype of the above system. Given the complex multivariable coupling models of the multiwinding transformer and multiple inverters, conventional single-variable theories are not suitable. Therefore, this paper presents a new decoupling analysis method. Using a proposed linear transformation matrix, the output currents of multiple inverters can be transformed to a summation (grid) current and difference currents, where the former is the summation of inverter currents and the latter are the differences between currents of any two inverters. This transformation has enabled the use of single-variable theories, e.g., Bode diagram to analyze the summation current and difference current separately. It was found that the MF oscillation issue is caused by the equivalent impedance of the summation current being much larger than that of the difference current. Specifically, using small controller parameters cannot ensure the grid current quality and using large parameters may cause oscillation in the difference current. The proposed method can provide guidelines to design the parameters of current regulators and filters in multiple-inverter systems. Experimental results of a downscaled wind energy conversion system are presented to verify the proposed method.

A Reliable Medium-Voltage High-Power Conversion System for MWs Wind Turbines

Analysis and Comparison of Medium Voltage High Power DC/DC Converters for Offshore Wind Energy Systems

A High Efficiency High Power Step-Up Resonant Switched-Capacitor Converter for Offshore Wind Energy Systems

Application of Modular Multilevel Converter in Medium Voltage High Power Permanent Magnet Synchronous Generator Wind Energy Conversion Systems

Control Strategy of Cascaded Multilevel Converter Based on Dual Active Bridge for Wind Energy Conversion System.

A Transformer-Less High-Power Converter for Large Permanent Magnet Wind Generator Systems

Analysis of the Medium-Frequency Oscillation Issue in a Medium-Voltage High-Power Wind Energy Conversion System

An AC Fault-Ride-through Strategy for MMC Intergrated with Energy Dissipating Resistors in Offshore Wind Power System

20 MW-Level Offshore Wind Power Converter Based on Single-Stage Hybrid Modular Multilevel Converter

The Modular Current-Fed High-Frequency Isolated Matrix Converters for Wind Energy Conversion

Power Converter Technologies for 20MW Wind Turbines

A Unidirectional Cascaded High-Power Wind Converter with Reduced Number of Active Devices

A New Power Conversion System for Megawatt PMSG Wind Turbines Using Four-Level Converters and a Simple Control Scheme Based on Two-Step Model Predictive Strategy—Part I: Modeling and Theoretical Analysis

Bidirectional Modular Multilevel Resonant DC Converter for MVDC and LVDC Application

A Modular Multilevel Converter With Integrated Energy Dissipation Equipment for Offshore Wind VSC-HVDC System

ISOS-SAB DC/DC Converter for Large-Capacity Offshore Wind Turbine

A Modular Direct-Drive Permanent Magnet Wind Generator System Eliminating the Grid-Side Transformer

Design of a Modular, High Step-Up Ratio DC–DC Converter for HVDC Applications Integrating Offshore Wind Power

Series-Parallel Multiple Integrated Modular Multilevel DC-DC Converter for All-DC Offshore Wind Power System

Improved Topology and Control Strategies for DC Converters in Wind Power Full DC Systems

Voltage-Fed Isolated Matrix-Type AC/DC Converter for Wind Energy Conversion System