Abstract:This paper proposes a multiobjective control method based on the combination of optimal‐vector‐pair modulated model predictive control (OVP‐M2PC) and a phase‐shifted modulation strategy for a unidirectional five‐level rectifier. Compared with traditional FCS‐MPC, under the proposed control strategy, complex cost function calculation and weighting factor tuning are not required, which much reduced computational burden. Multiobjective control is achieved with better performance in both steady‐state and dynamic conditions. The unidirectional multilevel rectifier has immense potential in high‐power medium‐voltage industrial applications. This paper proposes a multiobjective control method based on the combination of optimal‐vector‐pair modulated model predictive control (OVP‐M2PC) and a phase‐shifted modulation strategy for a unidirectional five‐level rectifier. This strategy takes both of the inductor current tracking and capacitor voltage balancing as the control objectives. First, an optimal vector pair is determined based on the AC‐side current variation rate, and then, through combining the calculated action duration of OVP with carrier phase‐shifted modulation, inductor current tracking is achieved. Second, capacitor voltage balancing control is carried out by compensating for the duty cycles which also decouples the input current tracking and output capacitor voltage balance control. Compared with traditional FCS‐MPC, under the proposed control strategy, complex cost function calculation and weighting factor tuning are not required, which much reduced computational burden. Multiobjective control is achieved with better performance in both steady‐state and dynamic conditions. The superiority of the proposed strategy over traditional FCS‐MPC are validated through simulations and hardware experiments.

Multi-mode Control Strategy for Primary-Side Regulation System

PWM/PSM Dual-Mode Controller for High Efficiency DC-DC Buck Converter

Design and Implementation of High-Efficiency and Low-Power DC-DC Converter with PWM/PFM Modes

Multi-mode control strategy in three-level DC-DC converter for higher efficiency operation under light-load and standby conditions

A Novel Digital Multi-Mode Control Strategy With Psm For Primary-Side Flyback Converter

Seamless Mode-Switch Control Scheme for Primary Side Regulation Flyback with Capacitorless Self-Adaptive Startup

An Adaptive Multi-Mode PWM Control PSR Flyback Converter.

A Simplified Model Predictive Control Strategy for a Nine-Level Hybrid Multilevel Converter

Improved PWM Modulation Strategy for CHB Multilevel Converter

New Digital Control Method for Improving Dynamic Response of Synchronous Rectified PSR Flyback Converter With CCM and DCM Modes

Novel Sensorless Current Multimode Control for PSR Double-Clamp ZVS (DCZVS) Flyback Converter in DCM and CrCM

Unified Pulsewidth-Cycle Control Strategy To Achieve Mixed Dcm/Crm Operation And Consistent Valley Switching For Boost Pfc Converter

A Simple Average Current Control with Time‐length Equality for Primary‐side Regulation Flyback Converter with Constant Output Current Control

A Dual-Sided Control Strategy Based on Mode Switching for Efficiency Optimization in Wireless Power Transfer System

A Novel Constant Current and Constant Voltage Adaptive Blanking Regulation Scheme for Primary-Side Controlled Flyback Converter

A Hybrid Multiobjective Control Strategy Based on Combination of Modulated Model Predictive Control and Phase‐Shifted Modulation for a Unidirectional Five‐Level Rectifier

A Low-Cost Constant Current Control Method for DCM and CCM in Digitally Controlled Primary-Side Regulation Flyback Converter

Quasi-Peak Current Control Strategy for Four-Switch Buck-Boost Converter

Unified Control of Multimode Operation for Paralleled Power Conversion System in Integrative Station

Multi-mode Controller IC for Soft-Switched Flyback Converter with High Efficiency over the Entire Load Range

PI Sliding Mode Control Strategy for Multi-Channel Interleaved Bi-Directional DC-DC Converter