Abstract:Heat transfer has a profound influence on homogeneous charge compression ignition combustion. When a thermal barrier coating is applied to the combustion chamber, the insulating effect magnifies the wall temperature swing, decreasing heat transfer during combustion. This enables improvements in both thermal and combustion efficiency without the detrimental impacts of intake charge heating. Increasing the temperature swing requires coatings with lower thermal conductivity and heat capacity. A promising avenue for simultaneously decreasing both thermal conductivity and capacity is to increase the porosity fraction. A proprietary solution precursor plasma spray process enables discrete organization of the porosity structure, called inter-pass boundaries, which in turn produces a step-reduction in thermal conductivity for a given porosity level. In this investigation, yttria-stabilized zirconia is used to create four different thermal barrier coatings to study the potential of structured porosity as means of improving the “temperature swing” behavior in a homogeneous charge compression ignition engine. The baseline coating is “dense YSZ,” applied using a standard air-plasma spray process. Next, significant reductions of the thermal conductivity are achieved by utilizing the solution precursor plasma spray process to create inter-pass boundaries with a moderate overall porosity. Performance, efficiency, and emissions are compared against both a baseline configuration with a metal piston and an air-plasma spray “dense YSZ” coating. Experiments are carried out in a single-cylinder gasoline homogeneous charge compression ignition engine with exhaust re-induction. Experiments indicate that incorporating structured porosity into thermal barrier coatings produces tangible gains in combustion and thermal efficiencies. However, there is an upper limit to porosity levels acceptable for homogeneous charge compression ignition engine application because an elevated porosity fraction leads to excessive surface roughness and undesirable fuel interactions. Comparison of the coatings showed the best results with coating thickness of up to 150 μm. Thicker coatings led to slower surface temperature response and attenuated swing temperature magnitude.

Effect Of Ceramic Coated Pistons On The Performance Of A Compressed Natural Gas Engine

Effect of Bowl-in-Piston Chamber on the Combustion Process in a Stoichiometric Natural-Gas Spark-Ignition Engine

Effect Of Piston Crevices On The Numerical Simulation Of A Heavy-Duty Diesel Engine Retrofitted To Natural-Gas Spark-Ignition Operation

Effect of Piston Crevices on 3D Simulation of a Heavy-Duty Diesel Engine Retrofitted to Natural Gas Spark Ignition

A numerical evaluation and guideline for thermal barrier coatings on gasoline compression ignition engines

Study on thermal-mechanical coupling of the ceramic layer in diesel engine piston with thermal barrier coating

Impact of thermal swing piston top land coatings on gasoline engine performance and raw emissions

The impact of piston thermal barrier coating roughness on high-load diesel operation

Low thermal inertia thermal barrier coatings for spark ignition engines: An experimental study

Numerical investigation of thermal barrier coating on performance and emissions of HPDI dual-fuel engine

Effect of piston bowl geometry and spray angle on engine performance and emissions in HCCI engine using multi‐stage injection strategy

Finite element analysis of thermal barrier properties under relevance vector machine in coated pistons and blades

Analysis of thermal barrier coated pistons in the COMSOL and the effects of their use with water + ethanol doped biodiesel

Performance evaluation of low heat rejection diesel engine operated with biofuels under-selective catalytic reduction

Investigation on the effect of thermal barrier coating at different dosing levels of cerium oxide nanoparticle fuel on diesel in a CI engine

Experimental investigation of the relationship between thermal barrier coating structured porosity and homogeneous charge compression ignition engine combustion

Influence of thermal barrier coating on partially premixed combustion in internal combustion engine

Experimental and simulation study on aluminium alloy piston based on thermal barrier coating

Numerical investigation of the effect of thermal barrier coating on combustion and emissions in a diesel engine

Influence of Heat Transfer of Combustion Chamber Wall on the Performance of Gasoline Engine Based on Polishing Technology under Different Compression Ratio and Air-Fuel Ratio

Optimization of Performance and Emission Characteristics of Catalytic Coated IC Engine with Biodiesel Using Grey-Taguchi Method