Abstract:The adaptability of vehicle-mounted heating systems that include burner and stove remarkably influences the system efficiency, heat flux uniformity, and pollutants emission. In this work, the performance of a rotary cup burner assembly with three different cooking stoves was investigated using ANSYS Fluent software based on five factors of thermal efficiency, heat transfer intensity, heating uniformity, CO emissions, and flue gas outlet temperature. The Eulerian-Lagrangian method was used to perform the diesel spray, and the shear stress transfer k-ω turbulence model and the probability density function model were employed to simulate the turbulent combustion. Based on the simulation results, the performance pentagon of the above five factors was constructed to evaluate the comprehensive performance of the new rotary cup burner system. The rotary cup burner had a good performance when it is used in two staple food stoves and a subsidiary food stove. In staple food stove A, its higher furnace increased the heat exchange area of the vessel, while the higher fireboard of staple food stove B caused a higher heat transfer intensity at the bottom of the vessel. However, the higher fireboard also led to higher CO emissions. In consideration of these two factors, the thermal efficiency of stove A was about 7% higher than that of stove B. Different from the staple food stove, the furnace of subsidiary food stove C had better wrapping to the bottom of the boiler so that it had the highest heat transfer intensity. The obtained performance pentagon shows that the comprehensive adaptability performance of stove A was the best and that of stove B was the worst, which is mainly caused by the height of the fireboard and the shape of the vessel. This research guides the optimization of the heating system and promotes the application of the rotary cup burner.

Numerical Simulation On Structure Optimization For Hot-Blast Stove Burner

Experimental and Numerical Study of a Two-Stage Swirl Burner

OXYGEN-ENRICHED COMBUSTION IN A HORIZONTAL FURNACE AND THREE- DIMENTIONAL NUMERICAL SIMULATION TEST THEREOF

Numerical Investigation of Different Burner Arrangement on A Coal-Fired Boiler

Numerical Simulation of the Aerodynamic Field of a New Type Bluff Body Steady Burner

Numerical simulation of combustion distribution in a gas burner

An Investigation of Rotary Cup Burner Assembly with Three Vehicle-Mounted Cooking Stoves by Numerical Evaluation Method

Numerical Simulation of Combustion in 35 t/h Industrial Pulverized Coal Furnace with Burners Arranged on Front Wall

Simulation of temperature field of sintering ignition furnace

The Structural Design of and Experimental Research on a Coke Oven Gas Burner

Numerical Simulation Of The Combustion Processes In A W-Shaped Boiler Furnace Under Different Operating Conditions

Numerical Modeling Of Full-Oxygen Combustion In An Unit Glass Furnace

Investigation of NOx emission under different burner structures with the optimized combustion model

Numerical Simulation Study on the Thermal Efficiency of Hot Blast Stoves

Numerical Simulation of Temperature Field in Blast Furnace Gas Regenerative Furnace

Numerical Simulation of NO x Emission Characteristics of a Cyclone Boiler with Slag-Tap Furnace

Numerical Simulation of Fuel- Staged Burner in Tube Furnace

Numerical investigation on the optimized arrangement for high-temperature corrosion after low NOx transformation

Numerical Study of the Combustion Process in the Vertical Heating Flue of Air Staging Coke Oven

Numerical Simulation for Gas-solid Two-phase Flow in New Type Rich-lean Steady Burner

3D thermodynamics and parameters analysis of the external combustion hot blast stove