Abstract:The paper focuses on an experimental investigation of the high-temperature resistance performance of TRC thin-plates with different cementitious materials. The effects of different cement matrix materials on the bearing capacity of the thin-plates were compared by using the unstressed residual temperature test method (URT). The results indicated that, from the macro view, TRC thin-plates with epoxy resin impregnated textile (type 1) exhibited obvious brittle failure characteristics no matter which kind of cementitious materials was selected. The bursting ratio of type 1 was 100% when the target temperature (T-R) reached 400 degrees C; while TRC thin-plates with non-impregnated textile (type 2) were characterized by ductility. When T-R <= 600 degrees C, no significant difference in the bearing capacity was observed between the type 2 specimens using alumina cement as matrix (CAC specimens) or using ordinary Portland cement as matrix (OPC specimens). The bearing capacity of CAC specimens after 800 degrees C could be up to 32% of that at room temperature, which is 1.7 times of OPC specimens. Furthermore, the surface of CAC specimens did not crack or flake off which proved a better high-temperature resistance performance than OPC specimens. On the other hand from the micro perspective, thermogravimetric analysis, pore distribution and micro-structural analysis were performed to evaluate the degradation of the damaged specimens using thermogravimetric analyzer (TGA), mercury intrusion porosimeter and an environmental scanning electron microscope (SEM), respectively. The results showed that declination of bearing capacity after high temperature was mainly due to degraded filaments, the increasing pore size of matrix and the decreasing bonding between fiber and matrix. The average pore diameter of CAC matrix was only 28% of OPC matrix after 800 degrees C; and the loss in strength of CAC matrix was obviously less severe than that of OPC matrix between 600 degrees C and 800 degrees C. Conclusively, using high alumina cement as matrix could effectively reduce the thermal degradation of the matrix at high temperatures. (C) 2016 Elsevier Ltd. All rights reserved.

Thick-Film Resistors On Glass Ceramic Substrates As Smart Strain Sensing Aggregates For Shm

Investigation of sensing performances of thick-film resistors sintered on fluorophlogopite glass-ceramic substrates

MICROSTRUCTURE AND PROPERTIES OF THICK FILM RESISTORS ON FLUOROPHLOGOPITE GLASS CERAMIC SUBSTRATE

Strain Sensor Made by Thick-film Resistors on Substrates of Glass Ceramic

FRP Confined Smart Concrete/mortar

Temperature characteristics of thick-film resistors and its application as a strain sensor with low temperature-sensitivity

Influence of Cementitious Material Infiltration on Piezoresistive Effect of Carbon Fiber Bundle

Carbon fiber reinforced cement and its stress sensor

Piezoresistive Behavior in Cement-Based Sensors: Nonlinear Modeling and Preliminary Application

Development and Performance Research of Fbg Strain Sensor for Monitoring on Asphalt Concrete Pavement

Highly conductive and sensitive piezoresistive cement mortar with graphene coated aggregates and carbon fiber

Effect Of Temperature On Electrical Property Of Carbin Black-Filled Cement-Based Composites

Strain sensing property of carbon black filled cement-based composites

Research on Fabrication Technique and Sensing Properties of Smart FRP-FBG Composite Laminates

Effect of Compressive Strain on Electrical Resistivity of Carbon Black-Filled Cement-Based Composites

Effect of Carbon Black on the Strain Sensing Property of 3D Printed Conductive Polymer Composites

Temperature‐independent conductive ceramic for high‐temperature strain sensing applications

The High-Temperature Resistance Performance of Trc Thin-Plates with Different Cementitious Materials: Experimental Study

Preparation and Piezoresistive Properties of Carbon Fiber-Reinforced Alkali-Activated Fly Ash/slag Mortar

Dynamic Mechanical Properties of Slag Mortar with Alkali-Resistant Glass Fiber

The influence of firing procedures on strain sensitivity of thick-film resistors