Abstract:For an optimized maintenance strategy, the early detection of track defects is necessary. Mounted sensors (e.g. acceleration sensors) on in-service trains are very suitable for track monitoring. With the continuous measurement of axle-box acceleration, short wavelength defects can be identified. For example, these defects can be rail breaks or cracks (i.e. rail defects), or local instabilities. Local instabilities can reduce the track quality in a short period of time. For an efficient data analysis of the acceleration signal and classification of different track defects, the development of appropriate methods is necessary. Therefore, a track-vehicle scale model was built to generate acceleration data for typical types of failures. With the generated dataset, developed algorithms for pattern recognition can be easily tested. In the second part of this research, three models created by the supervised learning method are trained and tested for the detection of the local instability in the vertical acceleration signal. The model A is trained with 78 laps and uses a manual classification. The chosen classifier for the model is a bagged tree algorithm implemented in the software MATLAB. The developed models distinguished between no failure, rail defect and local instability. For the training process of the model, the measured acceleration is treated statistically (e.g. Root-mean-square, Standard deviation, Spectral peaks and power). Subsequently test data for different scenarios is generated and used in the prediction model. With this model the track defects in the track-vehicle scale model are detected and classified very reliably. In contrast to existing methods, a machine learning approach is used for the non-destructive detection of the local instability. The results of the model are also improved by the model B and C by using 139 laps as training data, an automatic classification and an optimization of the statistics. The knowledge gained, can be used for acceleration data from inservice trains in regular operation, by adapting the developed model.

Track irregularity fault identification Based on Evidence Reasoning rule

Track Irregularities Estimation Based on Acceleration Measurements

Track Irregularity Assessment in High-Speed Rail by Incorporating Carriage-Body Acceleration with Transfer Function

Track Irregularities Estimation Based on the Vibration of Car-Body

Identification of track irregularities with the multi-sensor acceleration measurements of vehicle dynamic responses

Design of Onboard Device to Diagnose Track Fault Online

Estimation of railway track longitudinal irregularity using vehicle response with information compression and Bayesian deep learning

Identification of Subway Track Irregularities Based on Detection Data of Portable Detector

Research on Fault Detection and Isolation of Railway Vehicle Suspension System by Impulse Track Irregularity

Rail defect detection based on vibration acceleration signals

Fault Diagnosis of High Speed Train Bogie Based on Ensemble Empirical Mode Decomposition

Study of Ground Vibration from Trains Caused by Track Irregularities

Quantitative Detection of Vertical Track Irregularities under Non-Stationary Conditions with Variable Vehicle Speed

A Multi-sensor Approach Integrating Cyclostationary Analysis and Evidence Theory for Explainable Bearing Fault Diagnosis

On-Board Detection of Longitudinal Track Irregularity Via Axle Box Acceleration in HSR

Seismic-Induced Geometric Irregularity of Rail Alignment under Transverse Random Earthquake

Vibration Characteristics of Defective Axle Box Bearings in High-Speed Trains under Track Irregularity Excitation

Random Field Modeling of Track Irregularity of Beijing-Guangzhou High-Speed Railway with Karhunen-Loève Expansion

Squats and corrugation detection of railway track based on time-frequency analysis by using bogie acceleration measurements

Correlation analysis method of track irregularity indexes

Recognition of track defects through measured acceleration - part 2