Abstract:Large-mode-area photonic crystal fiber is used to generate high power, high beam quality supercontinuum. Propagation and supercontinuum generation process of laser pulse in large-mode-area (LMA) photonic crystal fiber (PCF) is simulated by solving the general nonlinear Schrödinger equation (GNLSE) using the split-step Fourier method. Effects of the pump pulse parameters (peak power and chirp) and the length of photonic crystal fiber used on supercontinuum generation are particularly estimated. Nonlinear spectral broadening mechanism of laser pulse in large-mode-area photonic crystal fiber is discussed. The results show that the process of supercontinuum generation can be divided into three stages: initial broadening, dramatic broadening and saturation broadening. The spectrum width and efficiency can be achieved by the optimized length of LMA PCF to insure output of the generated supercontinuum at the dramatic broadening stage. The pump peak power and chirp have important impact on supercontinuum generation. When a small peak power pump is input, the spectrum broadens symmetrically. When the pump peak power increases, it brings little changes with the shorter wavelength component but broader of the longer wavelength component. The time-domain shape of the pulse exhibits concussion modulation as the effect of pulse breakup. When the pump chirp is positive, little influence is shown, except a shift of longer wavelength power by increasing the chirp. But the full width of the supercontinuum has little changes. While the pump chirp is negative and satisfy certain condition, the nonlinear is enhanced to facilitate the supercontinuum generation.

Supercontinuum Generation In Different Zero-Dispersion Photonic Crystal Fibers

Supercontinuum Generation in Submicrometer Diameter Silica Fibers

Supercontinuum generation based on nanofiber

Surface modification of ZnO nanosheets with Au/polyaniline and their properties

Experimental Analysis of the Dependence Factor During Supercontinuum Generation in Photonic Crystal Fiber

Experimental and Numerical Study of Supercontinuum Generation in Photonic Crystal Fiber

[Study on the Supercontinuum Generation with Femtosecond Pulse in Photonic Crystal Fiber].

Supercontinuum Generation in Photonic Crystal Fiber and Tapered Single-Mode Fiber

19-Fs Pulse Generated by Supercontinuum Compression

Supercontinuum generation and control from large-mode-area photonic crystal fiber

Two Octaves Supercontinuum Generation in Lead-Bismuth Glass Based Photonic Crystal Fiber

Efficient dispersion engineering for three-octave-spanning supercontinuum generation in nanophotonic waveguides

Supercontinuum generation in photonic crystal fibers infiltrated with tetrachloroethylene

Circular lattice benzene-core PCFs with flat near-zero dispersion for low-power broad-spectrum supercontinuum generation

An Efficient Method for Supercontinuum Generation in Dispersion-Tailored Lead-Silicate Fiber Taper

Design and analysis of the C 6 H 6 -filled circular photonic crystal fiber with ultra-flat dispersion for broadband supercontinuum generation with peak power of 130 W and 250 W

Numerical investigation of a wideband supercontinuum source based on a large-mode-area photonic crystal fiber pumped at 1.3 μm

Supercontinuum Generation in Photonic Crystal Fibers Possessing High Birefringence and Large Optical Nonlinearity

Supercontinuum generation in the vacuum ultraviolet through dispersive-wave and soliton-plasma interaction in noble-gas-filled hollow-core photonic crystal fiber

74 Nm, 2.5 GHz Supercontinuum Generation in a Dispersion-Shifted Fiber

2-10 μm Mid-infrared Supercontinuum Generation in As2Se3 Photonic Crystal Fiber