Abstract:The compression of insulation causes around a heating, ventilation, and air-conditioning duct usually resulted in dew formation around the outer surfaces because of low temperature, which causes significant energy and financial losses. The parameters such as supply air flow rate, supply air temperature, ambient air speed, and the convective heat transfer coefficient (h o ) plays significant role in dew formation. In this paper, the parametric study is performed to investigate the effects of these parameters on the external surface temperature of the duct to avoid condensation. A mathematical model is developed to quantify these effects using preliminary data obtained from the heating, ventilation, and air-conditioning system of a pharmaceutical company. The results reveal that external surface temperature increases with an increase in insulation thickness and supply air temperature, whereas it decreases with higher supply air flow rate. It is estimated that the minimum insulation thickness at joint and bend should be maintained between 15–55 and 15–35 mm, respectively, with a variation in h o between 6 and 22 W/m 2 K to avoid condensation. Additionally, it is estimated that air flow rate should be greater than 1.4 m 3 /s at 10 W/m 2 K and 2.2 m 3 /s at 22 W/m 2 K. Similarly, the ambient air speed should be greater than 2.8 m/s at 6 W/m 2 K, respectively. Practical application: Building services engineers have a paucity of information on the effects of the compression of heating, ventilation, and air-conditioning duct thermal insulation. It can cause condensation that will adversely affect the insulation material, thereby increasing the maintenance cost as well increasing the heat loss from the duct so affecting the conditions of supply air. Proper insulation thickness and operating parameters are important for building owners and operators to control ongoing expenses of buildings. This paper seeks to quantify the effect of insulation compression to improve understanding so that this important area may be properly considered by the building services engineer.

Study On Principles Of External Condensation Of Water Vapor In Pneumatic System

Study on Principle and Experiment of External Condensation of Water Vapor in Pneumatic System

Judgement of External Condensation on Pneumatic System

Study on the Performance of Dehumidifier in the Liquid Desiccant Air Conditioning System

Difference analysis of theoretical and experimental results of the liquid desiccant regenerative performance

Study on Application of Condensation Theory to Design of Steam Turbine

Experimental Investigation on Liquid Desiccant Air-Conditioning System

The enhancement effects of internal convection on the heat transport of condensing droplets out of pure steam and moist air

Research of Condensation Heat Transfer of Wall of Vertical Micro Water Vapor on External Tube

Study on Independent Air Conditioning System Based on the Temperature and Humidity of Rotary Dehumidifier and Heat Pipe

Study on Heat Transfer Performances Between the High Temperature Pneumatic Duct and the Cabin

Influence of Boundary Effect on Supersonic Flows and Non-Equilibrium Condensation in a Laval Nozzle for Natural Gas Dehydration

Effectiveness of Temperature and Humidity Treatment Processes: Unified Expression and Thermodynamic Analysis

Comparative Study of Double-Sided Spray Cooling System under Atmospheric and Sub-Atmospheric Ambient Pressures

AN EXPERIMENTAL STUDY ON HUMIDIFYING PERFORMANCES IN COUNTERCURRENT HUMIDIFIER

A Study of Moist Air Condensation Characteristics in a Transonic Flow System

Research on R134a Water-cooling Condenser Using External Micro-fin Tube

Parametric study of condensation at heating, ventilation, and air-conditioning duct's external surface

Progress in implementation of dropwise condensation

EXPERIMENT STUDY ON COOLING CAPACITY OF CAPILLARY-TUBE RADIATION AIR-CONDITIONER

EXPERIMENTAL RESEARCH ON THE INFLUENCE OF AIR IN-LEAKAGE UPON CONDENSER PERFORMANCE