A 900mhz Uhf Rfid Reader Transceiver in 0.18 Mu M Cmos Technology

Le Ye,Huailin Liao,Fei Song,Jiang Chen,Huilin Xiao,Ruiqiang Liu,Junhua Liu,Xinan Wang,Yangyuan Wang
2008-01-01
Abstract:This paper presents a UHF band (840MHz similar to 925MEz) RFID reader transceiver design for the protocols of EPC Class-1 Gen-2 and ISO/IEC 18000-6C. The architecture and modules for the proposed transceiver are described and implemented in a standard 0.18 mu m CMOS process. To suppress the leakage signal from transmitter to receiver, directional coupler and leakage cancellation circuit are introduced in the transceiver. A mixer with common-gate capacitor-cross-coup led input stage and vertical NPN switching stage is introduced to satisfy wideband matching and reduce 1/f noise corner. The transceiver, with an on-chip Power-amplifier (PA) driver to drive off-chip PA, supports DSB-ASK, SSB-ASK and PR-ASK modulation schemes. A sigma-delta PLL is also implemented for 250kHz channel hopping. Measurement results are given. Mixer achieves -8dBm P1dB and 6.25dB noise figure, phase noise of PLL is -127dBc/Hz @ 1MHz offset and settling time of channel hopping is within 30 mu s. Settling time of killing leakage is less than 15 mu s. The sensitivity of receiver can be -81dBm @ 40 kHz link frequency (LF). The total silicon area of the transceiver is 13mm(2), and draws 75mA for 1.8V supply voltage.
What problem does this paper attempt to address?