Abstract:The MAX phase has attracted much attention due to its unique properties combined with the merits of both metal and ceramic, including the low density, high electrical conductivity and good oxidation resistance, which makes it significant for possible applications in various high temperature or other environments. There is a lot of research work on Ti2AlX (X=C, N). However little research about thermodynamic properties at high pressure is carried out. So we study the structural, mechanical and thermodynamic properties of Ti2AlC and Ti2AlN at various pressures and temperatures. The first-principles calculations based on electronic density-functional theory framework are used to investigate the properties at various pressures. The cut-off energy is 350 eV. Converged results are achieved with 10102 special K-point meshes. The self-consistent convergence of total energy is set to be 5.010-6 eV/atom. According to the calculated structural parameters at various pressures, we can find that the ratios V/V0 (V0 denotes the system volume at 0 GPa) of Ti2AlX are reduced by 20.59% and 18.93%, respectively, so the compressibility of the system is strong. As the internal pressure increases, the curves of V/V0 become gentle. Then we calculate elastic constants at pressures ranging from 0 to 50 GPa in steps of 10 GPa. It is obvious that the Ti2AlX is mechanically stable because all of the elastic constants satisfy the Born stability criteria. The bulk modulus, shear modulus and Young's modulus linearly increase with internal pressure increasing, implying that the pressure can improve the resistance to volume deformation. The ductility and brittleness can be judged according to Pugh's criterion (ratio of bulk modulus to shear modulus B/G), and the brittle nature turns into ductile nature in a pressure range of 40-50 GPa for the Ti2AlX since the value of B/G exceeds 1.75. Finally, we study the thermodynamic properties at various pressures and temperatures based on the quasi-harmonic Debye approximation theory, including the bulk modulus, heat capacity and thermal expansion coefficient. The bulk modulus decreases with temperature increasing but increases with pressure increasing. The heat capacity at constant volume Cv and the heat capacity at constant pressure Cp have the same variation tendency, while Cv obeys the Dulong-Petit limit. It is easy to see that temperature and pressure have opposite influences on heat capacity and the effect of temperature is more significant than that of pressure. The effects of temperature and pressure on linear expansion coefficient mainly occur at low temperature and the effect of pressure is not so considerable when the pressure exceeds 30 GPa. Above all, the effects of temperature and pressure on thermodynamic properties are inverse.

Pressure Effects on the Thermal Properties of Graphite

High Pressure in Situ Differential Thermal Analysis of Na0.5Bi0.5TiO3 Phase Transitions Up to 5 GPa

Structural, Mechanical, and Thermodynamic Properties of Ti2AlX (X = C, N) at High Pressure

Anisotropy in Elasticity and Physical Properties of Ti2B under High Pressure

The Structural, Mechanical and Thermodynamic Properties of Ti-B Compounds under the Influence of Temperature and Pressure: First-principles Study

The effect of pressure on the structural, electronic and vibrational properties of solid carbon dioxide phases

Heat-treated Glassy Carbon under Pressure Exhibiting Superior Hardness, Strength and Elasticity

Effect of Pressure on the Evolution of Vitrinite Graphitized Mesophases: an Experimental Study on Anthracite under High Temperature and Pressure

Pressure effect of the mechanical, electronics and thermodynamic properties of Mg-B compounds A first-principles investigations

First-Principles Calculations: Structural, Anisotropic, and Electronic Properties of BC14 Carbon Under Pressure

First-principle Studies on the Mechanical, Thermodynamic and Electronic Properties of Β″-Mg3gd and Β′-Mg7gd Alloys under Pressure

Investigating the Effects of Confining Pressure on Graphite Material Failure Modes and Strength Criteria

Thermal conductivity of materials under pressure

Pressure-induced extreme anisotropic behavior of thermoelectric properties in crystalline β -CuSCN

The Effect of Stress Levels on the Coefficient of Thermal Expansion of a Fine-Grained Isotropic Nuclear Graphite

Effect of pore structure on the thermophysical and frictional properties of high-density graphite

Ab initio study of the mechanical properties and thermal conductivity of Bi2O2X (X = Se, Te) under pressure

The Pressure Dependence of the Structure and Superconducting Transition Temperature of Mgb2

Influence of high pressure on mechanical and electronic properties of C3060 allotropes—A first-principles investigation

Modelling the coefficient of thermal expansion in graphite crystals: implications of lattice strain due to irradiation and pressure

Anomalous phonon softening of G-band in compressed graphitic carbon nitride due to strong electrostatic repulsion