Abstract:With the development of the society and the times, traditional parametric design methods are witnessing a severe challenge due to the more and more complex physical systems. Thus, developing novel parametric analysis methods is very important for dealing with complex physical systems, refining useful parameters from numerous data, and proposing accurate prediction formulas. A spring slider system, a direct-current circuit system, a pipeline pressure drop system and a steady heat transfer model of flat plate system were described from the point of systemic parametric analysis method. Then, the key physical parameters in above four systems were summarized. Based on the comparative results, a novel systemic parametric design method, obstacle contained system (OCS) design method, was proposed. The OCS was made up of three elements: an obstacle element, a pass body element and a D-value element. With an abundant accurate data pole, the OCS design method could build the direct relationship of the obstacle element and the D-value element, which meant the simplification of the physical models and much easier to get relatively accurate results. Meanwhile, the design of pilot-control globe valve orifice was checked with both the OCS design method and the numerical simulation. The diameter of orifice on the valve core could influence the pressure difference and the maximum vapor rate inside pilot-control globe valves. Achieved by two different methods, the OCS design method and the numerical simulation, the results showed that the effects of orifice diameters on the pressure difference and the maximum vapor rate under different inlet velocities, were within 2% errors, which was reasonable and acceptable for the engineering application. In other words, the OCS design method was credible for parametric analysis. In future, the OCS design method has a broad application prospect to analyze various types of physical models especially in the era of big data.

Reliability And Reliability-Based Sensitivity Analysis Of Valve In Internal Combustion Engine

Virtual design of rigidity for valve train system in internal combustion engine

Valve Dynamic Characteristic and Stress Analysis of Reciprocating Compressor Under Stepless Capacity Regulation

Modeling and Analysis of Hydraulic Controlled Rotary Valve Excitation System

Pneumatic Resistance Network Analysis and Dimension Optimization of High Pressure Electronic Pneumatic Pressure Reducing Valve

The CFD Analysis of Cavitation Erosion and Structural Optimization for an Unloading Valve

Design and Simulation of a High Pressure Proportional Pneumatic Pressure Reducing Valve

Modeling and Parameter Sensitivity Analysis of Valve-controlled Helical Hydraulic Rotary Actuator System

Finite element analysis and topology optimization of direct-drive compressor valve

Dynamic Characteristics Analysis on High Parameter Steam Spring-Loaded Safety Valve

Unbalanced Force Analysis on Valve Core Clamping in Hydraulic Spool Valves

Analysis of Structural Strength in Diesel Engine Electro-hydraulic Variable Valve Timing System

Numerical Analysis about the Dynamic Properties of a Pressure Relief Valve and Improvement Measures

Thermo-mechanical Stress and Fatigue Damage Analysis on Multi-Stage High Pressure Reducing Valve

Analysis of Thermal Boundary Condition and FEA Calculation of Temperature Field for the Exhaust Valve of Diesel Engine

Obstacle Contained System (OCS) Design Method and Its Application in Valve Core Orifice Design of Pilot-Control Globe Valve

Reliability Assessment of Pressure Vessel Design Methods

Research on the Optimal Design of a Pilot Valve Controlling Cut-Off Valve

Three-dimensional Simulation and Prediction of Solenoid Valve Failure Mechanism Based on Finite Element Model

Intelligent Dual Response Surface Method for Reliability Sensitivity Analysis of Turbine Blisk

Design, Modeling, and Feasibility Analysis of Rotary Valve for Internal Combustion Engine