Abstract:This paper investigates the conducted electromagnetic interference (EMI) characteristics of an on-board multiplexing converter that utilizes paralleled silicon carbide (SiC) devices to achieve high efficiency and high-power density for the application in electric vehicles (EVs) and plug-in hybrid electric vehicles (PHEVs). The multiplexing converter can operate as a three-phase interleaved DC/DC converter with a peak output power of 60 kW or an integrated two-stage non-isolated on-board charger (OBC) with an output power of 6.6 kW. The novelty of this paper is that it reveals that in the DC/DC mode the series resonance between the input negative lead parasitic inductance and the high frequency transmission line effects of the input power inductor will increase the conducted EMI levels, which can be mitigated by optimizing the winding methods of the power inductor or by adding a small capacitor, and reveals that in the non-isolated OBC mode the shielded cable on the battery-side will increase the grid-side EMI in the low frequency ranges, which can be suppressed by integrated installation of EMI filters without affecting the system power density. Firstly, parasitic parameters of the components of the multiplexing converter, such as the power inductors, the SiC MOSFETs and the shielded cables, are extracted and validated with impedance measurements, and the corresponding equivalent circuit models are established. Then, the conducted EMI simulation models of the multiplexing converter in different working modes are established. The influence of different interference sources and different parasitic parameters on the system EMI characteristics are analyzed, and the effective EMI suppression measures are given without affecting the system power density. Finally, the conducted EMI characteristics of the multiplexing converter and the effectiveness of the proposed EMI suppression measures are tested and verified through experiments.

EMI Analysis of Full-SiC Integrated Power Module

Design of Low Parasitic Inductance SiC MOSFETs Halfbridge Power Modules

A Fast EMI Model Based on Equivalent Interference Sources in Medium-Voltage Cascaded H-Bridge System

Common-Mode EMI Mathematical Modeling Based on Inductive Coupling Theory in a Power Module With Parallel-Connected SiC MOSFETs

An Investigation of Near-field Radiated Emission for Silicon Carbide Power Module in Buck Converter

Analysis of A Low-Inductance Packaging Layout for Full-Sic Power Module Embedding Split Damping

A New Method for Power-Aware Signal Integrity Analysis with Spice Model of Power Distribution Network

System-Level Conducted EMI Model for SiC Powertrain of Electric Vehicles

Characteristics of SiC inverter powertrains on common-mode EMI noise

Simulation on SiC Based Three Phase Boost Power Factor Correction Rectifier Using MATLAB PLECS Model and Its Numerical Analysis Verification

Development of a steady state electrothermal cosimulation model of SiC power modules

Influence of System Layout on CM EMI Noise of SiC Electric Vehicle Powertrains

Multi-Domain Modeling and Design Optimization of Synchronous Rectifiers for SiC-Based High- Load-Current LLC Converter

An Efficient Method for Power Integrity and Emi Analysis of Advanced Packages

Conducted EMI Investigation of a SiC-Based Multiplexing Converter for EV/PHEV

Determining Far-Field EMI From Near-Field Coupling of a Power Converter

High-frequency modeling based EMC performance improvement of power supplies in inverters

Analysis of Gate Signal Interference in an Integrated SiC MOSFET Module

A Novel Approach for System Level Package Modeling to Address Signal and Power Integrity Issues

A Systematic Semi-Numerical Approach for Modeling of Signal and Power Integrity of Electronic Packages

Analytical PSpice model for SiC MOSFET based high power modules