Abstract:Precise frequency comparisons are becoming more urgent given the recent rapid progress in next-generation frequency standards. This paper describes a new type of bidirectional optical amplifier that overcomes the fiber loss limits that have prevented accurate frequency comparisons between widely separated places; such comparison is realized by bidirectionally transmitting wavelength-division-multiplexed (WDM) signals along a single fiber. The proposed optical amplifier has an optical isolator in each two-way channel divided by wavelength filters to suppress the optical reflection that causes amplification instability. The additional insertion optical loss due to this method is about 1.5 dB. The optical gain greater than 30 dB is obtained for both signals with good optical isolation of 65 dB. A radio-frequency reference signal can directly be sent by simple intensity modulation and direct detection (IM-DD) devices in the 1550-nm region widely used in telecommunication networks. Phase comparisons of the received signals and the frequency standards at each terminal are used for frequency comparisons. The amplifier is tested in the field using two hydrogen masers. A 120-km fiber with loss of 52.5 dB is used to connect the National Metrology Institute of Japan (NMIJ) to the University of Tokyo. Because of this loss, an amplifier is needed to realize sufficient receiving power. The frequency stability of the system with a 10-MHz direct transmission is evaluated by returning the optical signal from a halfway point [55 km from the NMIJ] where the amplifier is installed. The result is $2.6 \times 10^{-16}$ (Allan deviation) with the averaging time of $7 \times 10^{4}\ \hbox{s}$. The laboratory result is $8.7 \times 10^{-17}$ $(\tau = 4 \times 10^{4}\ \hbox{s})$. The amplifier's long-term stability is promising for stable frequency dissemination in addition to precise frequency comparisons.

The Role of Electric-Preamplifier Noise on Determining the Frequency Instability of the Optical-Comb Based Frequency Transfer System

The Frequency Transfer over 1000 Km of Fiber Using the Optical Frequency Comb

Remote Residual Instability Evaluation of Comb-Based Precise Frequency Transmission for Optical Clock

Generation and Noise Analysis of a Wide-Band Optical -Frequency Comb Based on Recirculating Frequency Shifter

Optimization of EDFA Operating Parameters of Gain, SNR and Input Power in Frequency Transfer System

Ultra-broadband dual-branch optical frequency comb with 10(-18) instability

Frequency Dissemination over 1000 Km Optical Fiber with 10−21 Frequency Instability

Precise Frequency Comparison System Using Bidirectional Optical Amplifiers

Frequency Stability Optimization of an OEO Using Phase-Locked-loop and Self-Injection-locking

Frequency-dependent Noise Figure Analysis of Continuous Photonic Time-Stretch System.

Frequency Comb-Based Multiple-Access Ultrastable Frequency Dissemination with 7 × 10(-17) Instability.

End-to-end topology for fiber comb based optical frequency transfer at the $10^{-21}$ level

RF Transfer by Optical Comb Over 50-km Fiber Link With $4.7\times 10^{-18}$ Instability

Dispersion-induced Amplitude to Phase Noise Up-Conversion

Relative Intensity Noise Comparison of Fiber Laser and Amplified Spontaneous Emission Sources

Analyzing the Influence of InGaAs Photodetectors in Comb-Based Frequency Transfer

A Robust Frequency Stabilized of Er:Fiber Frequency Comb with Relative Frequency Instability of E-18

Increasing Mode Instability Threshold by Mitigating Driver Noise in High Power Fiber Amplifiers

Parametric Optimization of the Practical Mixer Device in the Optical Comb Frequency Transfer System

Long-term stable frequency transfer over an urban fiber link using microwave phase stabilization.

Optical frequency comb transfer through 820-m-scale atmospheric turbulence for low-noise radiofrequency distribution