Abstract:The temporal Talbot effect supports the generation of RF signals with high purity in optical domain. This allows for example a remote RF generation without the need for costly high-end electronic circuits and resource sharing. However, one of the most interesting features of the approach is its inherent ability to suppress phase noise during the carrier generation process. Besides the comb laser source, the dispersive element is the key component in this upconversion scheme. Ideally, it provides the right amount of dispersion over the whole spectral range of the comb. Broader combs are expected to allow a higher degree of phase noise suppression. The simulation of phase noise of an RF tone generated by an optical scheme is challenging in terms of computational and memory effort. Therefore, a simulation tool taking advantage of the properties of the comb and the Talbot effect had to be developed. In this paper, the dependency of the phase noise suppression on the dispersion characteristic is investigated yielding an important input to the design of these elements. First, the implemented simulation tool and the simulation parameters ensuring a correct estimation of the phase noise before and after dispersion influence are introduced. Then, the effect of different dispersion characteristics on the phase noise behavior is analyzed. It could be shown and explained how the phase noise at different offset frequencies to the carrier is affected differently depending on the dispersion characteristic and also the comb width. Design rules for the required comb width as well as the acceptable variation of the produced dispersion from the ideal value depending on the demands for the phase noise improvements could be developed and will be presented.

Dispersion-induced Amplitude to Phase Noise Up-Conversion

Optical amplification and pulse interleaving for low noise photonic microwave generation

Influence of dispersive element on phase noise suppression in Talbot effect based optical upconversion scheme

Vector-dispersion Compensation and Pulse Pedestal Cancellation in a Femtosecond Nonlinear Amplification Fiber Laser System.

Photonic Microwave Up-Conversion of Vector Signals Based on an Optoelectronic Oscillator

Photonic Instantaneous Frequency Measurement with Digital Output Based on Dispersion Induced Power Fading Functions

Application of Four Wave Mixing in Precise Radio Frequency Dissemination Via Optical Fiber Link

Photonic microwave signals with zeptosecond level absolute timing noise

Suppression for Dispersion Induced Phase Noise of an Optically Generated Millimeter Wave Employing Optical Spectrum Processing

10 GHz Generation with Ultra-Low Phase Noise via the Transfer Oscillator Technique

Nonlinear Propagation of Optical Frequency Comb and Its Application in Phase Noise Detection

Effect of Pulse Duration Fluctuation on the Photodetection of a Train of Pulses from an Optical Frequency Comb

Premodulation-Free Microwave Frequency Up/Down-Conversion Using Optical-Fiber-Stimulated Brillouin Scattering

Characterization of the Photonic Generation of Phase-Coded Rf Signals Based on Pulse Shaping and Frequency-To-Time Mapping

Ultra-low Noise Microwave Signal Generation with an Optical Frequency Comb

Noise analysis of a quasi-phase-matched quantum frequency converter and higher-order counter-propagating SPDC

Impact of higher-order dispersion on frequency-modulated combs

Accurate Control of Optoelectronic Amplitude to Phase Noise Conversion in Photodetection of Ultra-Fast Optical Pulses.

A Microwave Photonics Equalizer for Overcoming Dispersion-Induced Distortions on Wideband Signals in Radio-Over-Fiber Links

Phase conjugation frequency dissemination based on harmonics of optical comb at 10 −17 instability level

A Simplified Model of Phase Evolution in Comb-based Time-frequency Transfer