An Investigation of the Microstructure and Mechanical Properties of Dental Zirconia Manufactured by Digital Light Processing 3D Printing.

Zi-Yu Mei,Yu-Qing Lu,Yu-Xin Lou,Jun-Jing Zhang,Man-Lin Sun,Hai-Yang Yu
DOI: https://doi.org/10.7518/hxkq.2021.05.013
2021-01-01
Abstract:OBJECTIVES:This study was performed to investigate the microstructure and mechanical properties of dental zirconia manufactured by digital light processing (DLP) 3D printing and the clinical application prospects of this material. METHODS:The experiment (DLP) group was zirconia manufactured by DLP 3D printing, and the control (MILL) group was milled zirconia. The density, grain size, and phase composition were measured to study the microstructure. Flexural strength was measured by using three-point bending tests, while Vickers hardness was determined through a Vickers hardness tester. Fracture toughness was tested using the single-edge V-notched beam method. RESULTS:Zirconia density of the DLP group was (6.019 8±0.021 3) g·cm-3, and the average grain size was (0.603 0±0.032 6) μm, but without statistical difference with the corresponding values of the MILL group (P>0.05). Tetragonal phase was found in the X-ray diffraction patterns of the DLP and MILL groups. The flexural strength of the DLP group was (1 012.7±125.5) MPa, and Vickers hardness was (1 238.5±10.8) HV1, which was slightly lower than that of the MILL group (P<0.05). The fracture toughness of the DLP group was (7.22±0.81) MPa·m1/2, which was not statistically different from that of the MILL group (P>0.05). CONCLUSIONS:Zirconia manufactured by DLP 3D printing had microstructure and mechanical properties similar to those of the milled zirconia. Only the flexural strength and the Vickers hardness of the experimental zirconia were slightly lower than those of the milled zirconia. Therefore, DLP-manufactured zirconia has a promising future for clinical use.
What problem does this paper attempt to address?