Abstract:This article presents practical design considerations and methodologies for a 28-GHz front-end module (FEM) in 22-nm fully depleted silicon on insulator (FD-SOI) CMOS technology for the fifth generation (5G) wireless communication. The design adopts a gain-boosting technique that is comprehensively analyzed with a transformer-based stacked-FET power amplifier (PA). Then, the co-design of the transmit/receive (T/R) switch with the PA and low-noise amplifier (LNA) is investigated, and an electrostatic-discharge (ESD)-aware T/R switch incorporating PA circuitry is proposed to leverage the Tx- and Rx-mode performance. Moreover, the robustness of standalone PA and Tx-mode FEM is simulated and experimentally verified. Furthermore, the ground return paths and supply parasitic paths of the adopted single-ended LNA together with the proposed T/R switch are studied, properly simulated, and assessed. Finally, the proposed PA topology is first verified standalone, exhibiting 32-dB power gain ( $G_{p}$ ), an 18.2-dBm output 1-dB compression point (OP1 dB), and a 31.1% power-added efficiency (PAE) at OP1 dB (PAE1 dB). Using this PA in the FEM yields a Tx-mode OP1 dB/PAE1 dB of 16 dBm/19.4%, and an average output power (Poutavg)/PAE of 10.1 dBm/8.3% for a 100-MHz bandwidth 256-QAM single-carrier signal at an error-vector magnitude (EVM) of −30 dB. In the Rx mode, noise figure (NF) and input-referred third-order intercept point (IIP3) are 3.2 and −5.4 dBm, respectively. A 2-kV human-body model (HBM) ESD protection of the FEM is predicted in transient simulations and measured with transmission line pulse (TLP) tests.

A 24-30-GHz TRX Front-End With High Linearity and Load-Variation Insensitivity for mm-Wave 5G in 0.13-m SiGe BiCMOS

A 24-30 GHz Balanced PA with High Linearity for Mm-Wave 5G in 130 Nm SiGe BiCMOS

A 24–30 GHz GaN Front-End MMIC with Coupled-Resonator Based Transmit/Receive Switch for 5G Millimeter-Wave Applications

A 24–44 GHz Broadband Transmit–Receive Front End in 0.13- Μ M SiGe BiCMOS for Multistandard 5G Applications

A Broadband Transmit-Receive Front-End with Three- /4-line-based T/R Switch for 5G FR2 Bands

A 24–29.5-GHz Highly Linear Phased-Array Transceiver Front-End in 65-nm CMOS Supporting 800-MHz 64-QAM and 400-MHz 256-QAM for 5G New Radio

Design and Analysis of a 28 GHz T/R Front-End Module in 22-nm FD-SOI CMOS Technology

A 24.3-to-44.8 GHz Reconfigurable Dual-Band T/R Front-End with an Implicit Switch-based Antenna Interface Supporting 600msym/s 64QAM

A 24–30-GHz Four-Element Phased Array Transceiver With Low Insertion Loss Compact T/R Switch and Bidirectional Phase Shifter for 5G Communication

A 24−30 GHz 8-element dual-polarized 5G FR2 phased-array transceiver IC with 20.8-dBm TX OP1dB and 4.1-dB RX NFin 65-nm CMOS

A 24-28 GHz Power and Area Efficient 4-Element Phased-Array Transceiver Front-End with 21.1%/16.6%transmitter Peak/OP1dB PAE Supporting 2.4 Gb/s in 256-QAM for 5-G Communications

A 24-30 GHz 8-Element Dual-Polarized 5G FR2 Phased-Array Transceiver IC with 20.8-Dbm TX OP1dB and 4.1-Db RX NF in 65-Nm CMOS

25.2 A 19.7-to-43.8ghz Power Amplifier with Broadband Linearization Technique in 28nm Bulk CMOS

A 39 GHz T/R Front-End Module in 65nm CMOS

A 10.56-Ghz Broadband Transceiver with Integrated T/R Switching Via Matching Network Reuse and 0.3–2.1-Ghz Baseband in 28-Nm CMOS Technology

A 24-30GHz Asymmetric SPDT Switch for 5G Millimeter-Wave Front-End

A 24.25-27.5 GHz Front-End Module with Transformer-Based T/R Switch for 5-G Communications

A Compact 19.7-to 43.8-Ghz Power Amplifier with 20.3-Dbm $p_{\mathrm{sat}}$ and 35.5% PAE in 28-Nm Bulk CMOS

A Ka-Band Front End Module in 0.15-Μm GaN Technology for 5G Millimeter-Wave Application

An 18–40 GHz Wideband Millimeter-wave Front-end in 0.13-\Mu \text{msige}$ BiCMOS with > 30\%$ Peak PAE