A RT-FDTD method of analyzing wireless propagation characteristics in underground mine

Xiaoyan Song,Gaomin Zhang,Chang Zhou

DOI: https://doi.org/10.1038/s41598-024-60151-1

IF: 4.6

2024-04-30

Scientific Reports

Abstract:Efficient communication is crucial in reducing injuries and fatalities in coal mine accidents, necessitating the study of simulation methods for mine communication. When transceiver antennas are positioned close to the same side of the tunnel, the simulation results from the Ray Tracing (RT) method exhibit significant errors. Additionally, the Finite-Difference Time-Domain (FDTD) method demands substantial computational resources. In response to these challenges, we propose a RT-FDTD method, guided by the law of conservation of energy. This approach involves dividing the mine tunnel into a cuboidal region, using the RT method to calculate the electric field strength on the cuboid's surface, and then employing this as the excitation source for the FDTD method. Subsequently, the FDTD method is used to calculate the electric field strength within the cuboid. Experimental results demonstrate that the RT-FDTD method effectively mitigates the limitations of the RT and FDTD methods, enhancing both the efficiency and accuracy of simulations in underground mine.

multidisciplinary sciences

What problem does this paper attempt to address?

The problem that this paper attempts to solve is the efficient and accurate simulation of wireless propagation characteristics in underground mines. Specifically:

1. **Limitations of existing methods**:
- When the transmitting and receiving antennas are close to the same side of the tunnel, there are significant errors in the simulation results of the Ray Tracing (RT) method.
- Although the Finite - Difference Time - Domain (FDTD) method can calculate the electromagnetic wave characteristics in complex mine environments with high precision, it requires a large amount of computing resources.

2. **Research background**:
- The effectiveness of mine communication systems is crucial for reducing casualties in coal mine accidents.
- The wireless propagation environment in underground mines is very different from that on the ground, mainly due to the complex geometric shapes and material properties of mine tunnels.
- Antennas are usually installed near the tunnel walls or the top to avoid interfering with pedestrian or vehicle traffic.

3. **Proposed method**:
- The paper proposes a new method that combines RT and FDTD methods - the RT - FDTD method, which is based on the law of conservation of energy.
- Specific steps include dividing the mine tunnel into a cubic area, using the RT method to calculate the electric field intensity on the surface of the cube, and using it as the excitation source of the FDTD method, and then using the FDTD method to calculate the electric field intensity inside the cube.

4. **Objectives and contributions**:
- The proposed RT - FDTD method aims to overcome the respective limitations of RT and FDTD methods and improve the simulation efficiency and accuracy.
- Regardless of the position of the transmitting and receiving antennas in the tunnel cross - section, the RT - FDTD method can consistently calculate the signal strength of electromagnetic waves at different frequencies.
- The experimental results show that this method has higher computational efficiency and accuracy in the analysis of electromagnetic wave propagation characteristics in technical mines.

Through this method, researchers hope to provide a valuable tool for the design and optimization of underground mine wireless communication systems.